Abstract:The flow fluidized bed reactor was applied to methanol-to-olefins research after some necessary improvements of traditional fixed flow bed reactor.Methanol decomposition probability before contacting the catalysts could be decreased to the lowest level by adjusting the pre-heater temperature and changing the material of descending feed pipe.The results of device repeatability and material balance investigation showed this reactor had good data repeatability and could achieve 97%of mass balance.The experiments about the effect of reaction temperature and water / methanol mass ratio on main products distribution were carried out based on the SAPO-34molecular sieve catalysts.The results of temperature experiments showed the temperature increase improved the ethylene selectivity greatly.As well as speed up the coke formation,the methanol conversion was almost 100%,and the C = 2 ～C = 4 selectivity could be over 90%.For eth-ylene as main product,the reaction temperature was suggested to choose 500 ℃ with C = 2 / C = 3 molar ratio of 1.5.For propylene as main product,the reaction temperature of 450～470 ℃ should be chosen with C = 2 / C = 3 molar ratio of 0.9～1.1.The results of water / methanol mass ratio experiment showed that increasing the water content could not only delay the coke formation rate,but also increase the ethylene selectivity remarkably,which could put the C = 2 / C = 3 molar ratio up to more than 2.0.Too much water would increase the energy consume and the load of reactor and products separator unavoidably no matter for ethylene or propylene as main products.Therefore,water / methanol mass ratio of 0.25～0.5was advocated.

Reaction-Regeneration Process of Methanol-to-Light Olefins in Fluidized Bed

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Simulation of multi-fluidized-bed in series for methanol to olefins

Characteristics of Coke Deposition over A Sapo-34 Catalyst in the Methanol-To-Olefins Reaction

Simulation and Analysis of the Regeneration Process of Methanol to Propylene

Performance analysis of methanol to olefins process in fluidized bed reactor

Methanol to Propylene Process in a Moving Bed Reactor with Byproducts Recycling: Kinetic Study and Reactor Simulation

Performances of Scale-up Prepared Catalyst for Methanol to Light Olefins

Enhanced Reaction Performances For Light Olefin Production From Butene Through Cofeeding Reaction With Methanol

Development and application of energy-saving process for methanol to olefins

Partial Regeneration of the Spent SAPO-34 Catalyst in the Methanol-to-Olefins Process Via Steam Gasification

Catalytic Activity and Reactor Simulation of Methanol to Olefins

Experimental Study on Flow Behavior in A Gas-Solid Fluidized Bed for the Methanol-To-Olefins Process

Technical development in the production of light olefins by using methanol

Study on Carbon Deposition on SAPO-34 Molecular Sieve Catalyst in Transformation of Methanol to Olefins

Comparative Study of MTO Kinetics over SAPO-34 Catalyst in Fixed and Fluidized Bed Reactors

Reaction and Deactivation Kinetics of Methanol-To-Olefins Process Based on A Special Tga Reactor

Solid Concentration in Circulating Fluidized Bed Reactor for the MTO Process

Analysis on the Formation of Byproducts in Methanol to Olefins Process

Cfd Modeling of Methanol to Olefins Process in A Fixed-Bed Reactor

Experimental Investigation on Solid Concentration in Gas-Solid Circulating Fluidized Bed for Methanol-to-Olefins Process