Abstract:By using the capacitive measurement principle, high-performance micromechanical accelerometers provide low noise and power consumption, cost efficiency, and reliability. Capacitive sensors based on changes in the gap between the electrodes, as a rule, require closed-loop control, which increases the level of complexity of the measurement circuit and increases power consumption. Capacitive sensitive elements with a change in the electrode overlap area have a good linearity of the capacitance versus displacement and a large measurement range, but they are more difficult to manufacture. This paper presents and investigates a model of a sensitive element of a sandwich design of a capacitive micromechanical accelerometer, the functioning of which is based on the use of a change in the relative dielectric constant of the dielectric of capacitors due to the introduction of a movable inertial mass between the electrodes of the capacitors, moving under the action of acceleration. As a result, there is a change in capacitance in the output measuring circuit. It is shown that the considered model is sensitive to acceleration and resistant to temperature changes, with low residual mechanical stress in the sensitive element. The modeling and calculations are performed using the Ansys and SolidWorks software. It is found that the movement of the moving mass along the axis of sensitivity X is more than five times the movement of the moving mass along the nonworking axes, and the change in the capacitance between the electrodes along the axis X is almost 2500 times more than the changes in capacitance between electrodes along the nonworking axes Z and Y . Calculations have shown that for all values of the acting acceleration (up to 30 g), the mechanical stress in the sensitive element is much less than the ultimate strength of silicon, equal to 440 MPa. It is found that variation of the temperature from –40 to 85°C leads to minor changes in capacitance along the working axis (0.0025–0.003 pF). This indicates the temperature stability of the investigated micromechanical accelerometer sensing element. The results of the analysis show that the developed and investigated model of the sensitive element of the sandwich design ensures the sensitivity of the micromechanical accelerometer and the stability of its parameters.

The Parasitic Capacitance's Influence on Noise in a MEMS Accelerometer Sensor

Noise Behaviors of a Closed-Loop Micro-Electromechanical System Capacitive Accelerometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Modeling and Noise Analysis of a Fence Structure Micromachined Capacitive Accelerometer System

A New Modeling Method of MEMS System's Noise

Modeling and Simulation of Micromachined Gyroscope

Thermal Stress Analysis of MEMS Accelerometer Based on Finite Element Method

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

Study on the influence of input capacitance to charge amplifier noise performance

Method of Eliminating Parasitic Capacitances in Micro Flow Measurement of MEMS Devices

A Verilog-A Model for Capacitive MEMS Accelerometers

An Analytical Model for Studying the Structural Effects and Optimization of A Capacitive Tactile Sensor Array

Modeling the Sensitive Element of the Sandwich Construction of a Capacitive Micromechanical Accelerometer, Taking into Account the Change in the Dielectric Constant

Reducing the Effect of Parasitic Capacitance on the Micro-capacitive Humidity Sensor

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

A Pseudo-Differential Capacitive MEMS Accelerometer Analog Front-End Design

Effect of Parasitic Capacitance on Impedance Measurement and Model Extraction

Improvement of Capacitive Accelerometers: Integrating Modeling, Electrode Design, Signal Processing, and Material Selection

Sensitivity and Noise Evaluation of a Bonded Magneto(elasto) Electric Laminated Sensor Based on In-Plane Magnetocapacitance Effect for Quasi-Static Magnetic Field Sensing

Modeling and Test for Parasitic Resistance and Capacitance Defects in PCM

Noise Analysis and Performance Improvement of a MEMS Fabry-Pérot Seismic Accelerometer