Abstract:The accumulation of surface charge generated by discharge at the solid-gas interface is an import factor that can affect PD characteristics. In this paper, the decay time of surface charge was measured by the surface charge measurement system based on Pockels effect, and the effect of surface charge decay on variation of partial discharge location was investigated by changing the cycle of applied voltage. As applied voltage cycle length increased, the coincidence rate of hetero-discharge location (CRHEL) before and after voltage zero-crossing point decreased. Besides, CRHEL from a void between two dielectric surfaces (called symmetrical electrode) was larger than that from a void between a dielectric surface and a metal surface (called asymmetrical electrode). Regarding asymmetrical electrode, CRHEL for the case with negative discharges occurring in the former half-cycle was larger than that with positive discharges occurring in the former half-cycle. However, there was almost no difference about CRHEL for these two cases when symmetrical electrode was used. After the applied voltage cycle length exceeded 500 ms, the coincidence phenomenon of homo-discharge location during negative half-cycle was observed in the usage of asymmetrical electrode, and the coincidence rate of homodischarge location (CRHOL) became larger with voltage cycle length increasing. As for symmetrical electrode, there was no coincidence of homo-discharge location. These results were attributed to the charge decay and difference of discharge initiation position.

Effects of Discharge Area and Surface Conductivity on Partial Discharge Behavior in Voids under Square Voltages

Transition Of Partial Discharge Behavior With Aging Under Square-Wave Ac Voltage

Study on the Characteristics of Partial Discharges in Voids under Square Voltage by Detecting Light Emission Intensity

The Contribution of Discharge Area Variation to Partial Discharge Patterns in Disc-Voids

Contribution of Surface Conductivity to the Current Forms of Partial Discharges in Voids

Partial Discharge Activity of Inter-turn Insulation under Different Parameters of Square Wave Voltage

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Comparison of Partial Discharge Characterizations under 60 Hz Sinusoidal Waveform and High-frequency PWM Waveform

Measurement and Analysis System for Partial Discharge under Continuous Square Pulse Voltage

Measurement for Partial Discharge and Analysis on Insulation Aging under Continuous Square Pulse Voltage

Dynamic Behavior of Surface Charge Distribution During Partial Discharge Sequences

Partial Discharges in SF6 Gas Filled Void under Standard Aperiodic and Oscillating Switching Impulses

Effect of Artificial Void Area on Partial Discharge Characters

Effect of Waveform Parameters of High Voltage Square-wave Pulse on Partial Discharge

Partial discharge characteristics of void defect in SF6 under stepped AC voltage

Phase Distribution Characteristics of Partial Discharge under Square Pulse Voltage

Partial Discharge Behavior of Typical Defects in Power Equipment under Multilevel Staircase Voltage

The Effect of Surface Charge Decay on Variation of Partial Discharge Location

Variation of Surface Charge Distribution in the Process of PD Degradation

Partial Discharge Aging of Epoxy Insulation at Different High-Frequency Pulse Parameters and Environmental Stresses

Partial Discharge Characteristics and Mechanism of Medium Voltage Power Cable Defects under Different Voltage Stresses