Abstract:Measurements of partial discharge play an important part in the study of dielectric materials, nevertheless, the physical processes of partial discharge are not yet clear. Pulse current method is recognized as the only effective way to quantify the charge. However, there is a limitation of such approach to detect PD pulses below the noise threshold and slow charge movement. In this work, a new technology “Excess Current Method” enables the measurement of the micro discharge and slow charge movements during PD. Proposed in some published studies, the excess current is referenced as the additional current component associated with the PD process by measuring the difference of dielectric response currents through a test object without and with PD activity. A measurement setup for simultaneous measurement of PD excess currents and PD currents averaged from about 300 periods is applied and three typical insulation defect models were tested under 50Hz voltage. Results of the excess currents during and after PD activity, including waveforms and charges are showed and discussed. The results indicate that the amplitude is higher and the charges are more of the excess currents than the PD currents, which reveals that some current components are ignored by pulsed current method but detected by excess current method. Furthermore, a weak excess current is measured for the dielectric barrier and air void PD models when the voltage dropped below the Partial Discharge Extinction Voltage (PDEV). The analysis of non-PD excess current also reflects the slow charge movements during PD. The measurement of excess current provides additional insight into PD mechanisms and shows the potential of completing the conventional PD detection.

Partial discharge characteristics of void defect in SF6 under stepped AC voltage

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

Partial Discharge Characteristics of Surface Defect in SF 6 Under Oscillating Impulse Voltage

Partial Discharge Characteristics of Typical Defects in 220 kV GIS under Standard Switching Impulse

Partial Discharges in SF6 Gas Filled Void under Standard Aperiodic and Oscillating Switching Impulses

Time-Frequency Characteristics of Partial Discharge of SF6 Gas in an Extremely Uneven Field under Impulse Voltage

Study on the Partial Discharge Characteristics and Development Process in Use of the Multiple Discharge Patterns for the Typical Defects in Gas-Insulated Switchgear

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator

Characteristics and Development Mechanisms of Partial Discharge in Sf6 Gas under Impulse Voltages

Partial Discharge Characteristics of Floating Potential Defect in SF6 Gas under Oscillating Lightning Impulse Voltage

Partial Discharges in SF6 Gas Filled Void under Standard Oscillating Lightning and Switching Impulses in Uniform and Non-Uniform Background Fields

Statistical Analysis of Partial Discharges in SF6 Gas Via Optical Detection in Various Spectral Ranges

Comparison of Partial Discharge Characterizations under 60 Hz Sinusoidal Waveform and High-frequency PWM Waveform

Partial Discharge Characteristics over Sf6/Epoxy Interfaces under Impulse Voltage

Partial Discharges in Void Defect of Gas Insulated Switchgear Insulator under Standard Aperiodic and Oscillating Switching Impulses

Partial Discharge Behavior of Typical Defects in Power Equipment under Multilevel Staircase Voltage

Effect of AC and Switching Impulse Superimposed Voltage on PD Characteristics in SF6 Gas

Excess Current Characteristics of Typical Insulation Defects Partial Discharge under 50Hz

Assessment of stages of partial discharge process of typical oil-paper insulation defect under combined AC-DC voltage

Experimental Investigation of Transient Earth Voltage and Acoustic Emission Measurements of Partial Discharge Signals in Medium-Voltage Switchgears