Abstract:Partial discharge measurement plays an important role in the assessment of insulation status and fault diagnosis of power equipment. Presently, the most commonly used industrial applications of PD detections are based on the broadband measurement systems that count amplified PD pulses. The limitations of these traditional measurements are that the system requires a relatively high sampling rate and calculation capability, and is very sensitive to the ambient noise. To eliminate noise interference and save the cost of PD detection system, a technique measurement of excess currents, which measures the dielectric response currents through test object before and after PD activities to capture the activities of PD, has been reported in some recent studies. This work aims to explore the parameters that characterize the PD activities via excess current technology and to seek new ideas for PD detection. In this work, a measurement setup for measurement of PD excess currents averaged from 300 periods is applied and three typical insulation defect models were tested under 50Hz voltages. Excess currents for each case are measured. Then the corresponding dielectric loss factors and circuit impedances are obtained by comparing them to the synchronous voltages. The results show that the loss factors increase after PD while the circuit impedances decrease. Meanwhile, the loss factors continue to increase and the circuit impedances continue to decrease as the voltages turn up where the rate of the change shows more rapid in the needle-plate model. Moreover, the loss factors and circuit impedances in the dielectric barrier model and air void model are respectively higher and lower than the values before PD when the voltages drop below the PD extinction voltages, which does not appear in the needle-plate model. These characteristics provide a new idea for PD detection by monitoring the loss factors or circuit impedances via excess current detection.

Partial Discharge Behavior of Typical Defects in Power Equipment under Multilevel Staircase Voltage

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Comparison of Partial Discharge Characterizations under 60 Hz Sinusoidal Waveform and High-frequency PWM Waveform

Characterizations of Partial Discharge in Modern Power Electronics

Partial Discharge Characteristics and Mechanism of Medium Voltage Power Cable Defects under Different Voltage Stresses

Experimental Investigation of Transient Earth Voltage and Acoustic Emission Measurements of Partial Discharge Signals in Medium-Voltage Switchgears

Study on the Partial Discharge Characteristics and Development Process in Use of the Multiple Discharge Patterns for the Typical Defects in Gas-Insulated Switchgear

Characteristics and Mechanism of Partial Discharge Behavior of Power Module Under Unipolar Square Voltage

Partial Discharge Pulse Shape Detection and Analysis under DC Condition in Typical Defect Models

Partial Discharge Characteristics Of Needle-Plane Defect In Oil-Paper Insulation Under Actual Stress In Converter Transformers

Partial discharge characteristics of void defect in SF6 under stepped AC voltage

Partial Discharge Characteristics of Typical Defects in 220 kV GIS under Standard Switching Impulse

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

Partial Discharge Detection and Assessment of Surface defects under Fast Rising Repetitive Square Voltage for MV Converter Application

Phase Distribution Characteristics of Partial Discharge under Square Pulse Voltage

Partial Discharge Behaviors Excited by High-Frequency Square Pulse Voltage in Cast Resin Insulation with Thermal-Induced Defect

Partial discharge theory and technologies related to medium-voltage electrical equipment

Partial Discharge Characteristics of Surface Defect in SF 6 Under Oscillating Impulse Voltage

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

Excess Current Characteristics of Typical Insulation Defects Partial Discharge under 50Hz