Abstract:Detection of partial discharge (PD) is an effective technical means to discover the sudden and developing insulation defects. PD is accompanied by a variety of transient physical phenomena, which are essentially the proliferation, disappearance and transfer of charge in the process of ionization. The current coupled in the circuit is an important indicator of the discharge. Measurement of current pulses developed by such principle has been the standard test method for insulation parts and has become the only criterion for calibrating the discharge capacity. However, the broadband measurement is insensitive to the low-frequency current, thus cannot detect the electric field-drive behavior of the slow charges generated by the PDs. To research the slow charge dynamic during PD, a narrowband measurement of detecting the excess current induced by PD is used in this work, and considering the horizontal and vertical path for the PD-induced current, a tri-electrode system is designed for dividing the current into the surface and the bulk part. Excess current is the current accompanying PD activities, which can be quantified by measuring the dielectric response current flowing through the defect before and during PD. The principle is based on the assumption that the capacitive current is proportional to the voltage. By canceling (removing) the capacitive current during the PD process, an excess current purely related to the PD is obtained. The experimental results show that the low frequency current which cannot be detected by the pulse current method does exist in the PD process. The amplitude of the excess current waveform is higher than the average discharge current, and the phase distribution is a little wider than the latter. The discharge quantity of the positive and negative current of the excess current is higher than that of the PD pulse current. The analysis of the net excess current reflects the current characteristics of the slow moving charge in the PD process. Through waveform analysis and geometric capacitance measurement, it can be seen that the presence of geometric capacity will have a large impact on the measurement of surface current.

Dynamic Behavior of Surface Charge Distribution During Partial Discharge Sequences

Variation of surface charge distribution in PD sequences

Simulation of Cavity PD Sequences at DC Voltage by Considering Surface Charge Decay

The Effect of Surface Charge Decay on Variation of Partial Discharge Location

The Dynamic Measurement of Surface Charge Distribution Deposited from Partial Discharge in Air by Pockels Effect Technique

Variation of Surface Charge Distribution in the Process of PD Degradation

Investigation of Factors Inducing Simultaneous Discharges in Voids

Effects of Photoionization and Overvoltage on Simultaneous Discharges

The Transition Of Surface Charge During Partial Discharge Sequences Under Low Pressure

Simulation of Partial Discharge Sequences Using Fluid Equations

The Contribution of Discharge Area Variation to Partial Discharge Patterns in Disc-Voids

Understanding Partial Discharge Behavior from the Memory Effect Induced by Residual Charges: A Review

Contribution of Surface Conductivity to the Current Forms of Partial Discharges in Voids

Dynamic Observation of Needle-Plane Surface-Discharge Using the Electro-Optical Pockels Effect

Effects of Discharge Area and Surface Conductivity on Partial Discharge Behavior in Voids under Square Voltages

Experimental Study of Transient Surface Charging During Dielectric Barrier Discharges in Air Gap in Needle-to-plane Geometry

The effect of discharge area variation on stochastic characters of PD magnitude

The Effect of PD Process on the Accumulation of Surface Charges

Measurement of Excess Current Accompanying Partial Discharge of Polymer Film in Tri-electrode System under Power Frequency Voltage

Numerical Modeling of Partial Discharges in a Solid Dielectric-bounded Cavity: A Review

Analysis of Polypropylene Surface Discharge Characteristics with Pulse Sequence Analysis