Abstract:Insulation of power electronic devices and converter station equipment is often under superimposed AC-DC voltage. The understanding of PD characteristics under AC-DC combined excitation plays an important role in designing the insulation of power electronic device. Previous researches focused on the stochastic features and mechanism under AC or DC voltages, while little attention was paid to the PD-induced charge movements under superimposed AC-DC field. The charge movements include the transient behavior of PD and the slow movement, which can be characterized by the transient PD current and the excess current respectively. In this paper, a composite AC-DC voltage is applied to a pair of rod-plane electrodes sandwiching epoxy film. And a sensitive high-frequency Rogowski coil and a capacitor-resistor shunt impedance are used to simultaneously measure the transient PD current and the excess current during PD. The excess current can be measured by cancelling the capacitive current from the total current. In the measurement, first set the AC voltage at 1.5 times the AC PDIV, then gradually raise the DC voltage up. The results show that, as the DC bias increases, the phase distributions of PD events are expanded, but the average PD currents and excess currents are lower than that under the pure AC electric field. Moreover, only few PD events are observed when the DC voltage rises close to the peak of AC voltage, and the surface flashover starts once the DC voltage rises above the peak of AC voltage. It is proved that the additional DC voltage suppress the corona discharge excited by the AC voltage to a certain extent, but it may also result in surface flashover if the DC bias exceeds the AC amplitude.

Effects of Photoionization and Overvoltage on Simultaneous Discharges

Investigation of Factors Inducing Simultaneous Discharges in Voids

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Dynamic Behavior of Surface Charge Distribution During Partial Discharge Sequences

Variation of surface charge distribution in PD sequences

The Effect of Surface Charge Decay on Variation of Partial Discharge Location

Effect of surface photoemission on discharge in PDP

Effect of photoionisation on initial discharge in air under nanosecond pulse voltage

Understanding Partial Discharge Behavior from the Memory Effect Induced by Residual Charges: A Review

The effect of discharge area variation on stochastic characters of PD magnitude

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Simulation of Cavity PD Sequences at DC Voltage by Considering Surface Charge Decay

Characteristics of the Partial Discharge-induced Current along Epoxy Resin Film under Superimposed AC-DC Voltage

Effect of Artificial Void Area on Partial Discharge Characters

The Dynamic Measurement of Surface Charge Distribution Deposited from Partial Discharge in Air by Pockels Effect Technique

Investigating the Influence of Free-Electron Pulses and Neutral Excited Species Formation on Discharge Development: By PD Quantum Optics Analysis and Plasma Simulation

Effects of Discharge Area and Surface Conductivity on Partial Discharge Behavior in Voids under Square Voltages

Space Charge Effects on Partial Discharge Activities Under Pulse Voltage

Study on the Characteristics of Partial Discharges in Voids under Square Voltage by Detecting Light Emission Intensity

The Transition Of Surface Charge During Partial Discharge Sequences Under Low Pressure

Influence of Epoxy Resin on Partial Discharge Development under Non-uniform Field