Transition characteristics of low-pressure discharges in a hollow cathode
Yangyang Fu,John P. Verboncoeur,Andrew Christlieb,Xinxin Wang
DOI: https://doi.org/10.1063/1.4997764
IF: 2.2
2017-01-01
Physics of Plasmas
Abstract:Based on a two-dimensional (2-D) fluid model, the transition processes of discharges in a hollow cathode at low pressure are observed by changing three parameters, i.e., applied voltage U-0, gas pressure p, and external circuit ballast resistance R-b. The voltage-current characteristic curves, electron density distributions, and electric potential distributions of different discharge operating points in a hollow cathode are obtained. The transition processes are characterized by the voltage-current characteristic curves, the electron density distributions, and the electrical potential distributions. The transition modes observed from the voltage-current characteristics include the low-current abnormal mode, normal mode, and high-current abnormal mode. Increasing the applied voltage U0 can have a similar effect on the discharge transition processes to decreasing the ballast resistance. By increasing U0 from 200V to 500V and decreasing Rb from 5000 k Omega to 100 k Omega independently, it is observed that the discharge transfers from the outside to the inside of the hollow cavity, thus forming the virtual anode potential. By increasing the gas pressure p from 50 Pa to 5 kPa, the discharge also moves into the hollow cavity from the outside; however, a further increase in the gas pressure leads to the discharge escaping from the hollow cavity. Simulation results and characterizations for different parameters are presented for the transition properties of low-pressure discharges in a hollow cathode. It is verified that the hollow cathode discharge only exists under certain ranges of the above parameters. Published by AIP Publishing.