Abstract:Although much work has been done and significant progress has been made on partial discharges (PD) measurement and detection techniques, this is not the case for PD modeling. Four types of internal PD modeling, in sequential order from first to last developed, are three-capacitance (abc), induced charge concept (ICC), finite element analysis (FEA), and Multiphysics models. The abc model is too simple to provide an understanding of the physical phenomena affecting PD. In contrast, Multiphysics models are immature. Multiphysics models require a high number of physical parameters that need to be experimentally determined, which is not a trivial task. Moreover, adjusting the physical parameters to achieve a good agreement between simulation results and measurement results for a specific geometry and dimension may not work for other geometries and dimensions. The FEA model, a relatively recent model, and the ICC model, which fall between the abc and Multiphysics models in terms of modeling complexity, can partly explain mechanisms and physical phenomena associated with internal PD. However, to the best of our knowledge, there is only one paper comparing ICC and FEA models for a case study; thus, further research is needed to elucidate various aspects of these two models. In this paper, 1) an improved ICC and a FEA capable of describing phenomena occurring during PD are developed, 2) both developed models are coded and implemented either in MATLAB or in COMSOL Multiphysics linked with MATLAB, and their simulation results are compared and analyzed, and 3) the influence of different parameters including void shape, void size, and void air pressure on PD parameters are studied.

Numerical Modeling of Partial Discharges in a Solid Dielectric-bounded Cavity: A Review

Simulation of Cavity PD Sequences at DC Voltage by Considering Surface Charge Decay

Review of Partial Discharge Physical Model of Air Gap inside Solid Insulating Material

Understanding Partial Discharge Behavior from the Memory Effect Induced by Residual Charges: A Review

Study On The Partial Discharge Characteristics In Different Solid And Gaseous Dielectric By Simulation

Computer Simulation Of Partial Discharge In Void

A Finite Element Analysis and an Improved Induced Charge Concept for Partial Discharge Modeling

Simulation of Partial Discharge Sequences Using Fluid Equations

The Contribution of Discharge Area Variation to Partial Discharge Patterns in Disc-Voids

Dynamic Behavior of Surface Charge Distribution During Partial Discharge Sequences

Study on Modifying the Simulation Model and Computating the Key Parameters of Partial Discharge in Single Void

Computer Simulation of Partial Discharges in Voids inside Epoxy Resins Using Three-Capacitance and Analytical Models

A Comparative Study of Time-Evolution Characteristics of Single and Double Cavity Partial Discharges

The influence of cavity's parameters within polyimide material on partial discharge

PD Signal Detection Model Based on Multiscale Simulation of EM Generation and Transmission.

Variation of surface charge distribution in PD sequences

Critical Study of Partial Discharge Inception in Voids: Statistical Behavior to Stochastic Nature

Space-Charge Accumulation and Its Impact on High-Voltage Power Module Partial Discharge Under DC and PWM Waves: Testing and Modeling

Electrical Modeling of Dielectric Barrier Discharge Considering Surface Charge on the Plasma Modified Material

Numerical Simulation Research on Partial Discharge of Particle Defects at Epoxy Interface Excited by High-Frequency Sinusoidal Voltage

Partial Discharge Pulse Shape Detection and Analysis under DC Condition in Typical Defect Models