Abstract:Measurements of partial discharge play an important part in the study of dielectric materials, nevertheless, the physical processes of partial discharge are not yet clear. Pulse current method is recognized as the only effective way to quantify the charge. However, there is a limitation of such approach to detect PD pulses below the noise threshold and slow charge movement. In this work, a new technology “Excess Current Method” enables the measurement of the micro discharge and slow charge movements during PD. Proposed in some published studies, the excess current is referenced as the additional current component associated with the PD process by measuring the difference of dielectric response currents through a test object without and with PD activity. A measurement setup for simultaneous measurement of PD excess currents and PD currents averaged from about 300 periods is applied and three typical insulation defect models were tested under 50Hz voltage. Results of the excess currents during and after PD activity, including waveforms and charges are showed and discussed. The results indicate that the amplitude is higher and the charges are more of the excess currents than the PD currents, which reveals that some current components are ignored by pulsed current method but detected by excess current method. Furthermore, a weak excess current is measured for the dielectric barrier and air void PD models when the voltage dropped below the Partial Discharge Extinction Voltage (PDEV). The analysis of non-PD excess current also reflects the slow charge movements during PD. The measurement of excess current provides additional insight into PD mechanisms and shows the potential of completing the conventional PD detection.

Critical Study of Partial Discharge Inception in Voids: Statistical Behavior to Stochastic Nature

Study on the Characteristics of Partial Discharges in Voids under Square Voltage by Detecting Light Emission Intensity

Influencing Factors on Characteristics of Partial Discharge in Void of Insulating Materials

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Size Effect of Partial Discharge in Solid Void Defects

Study On The Partial Discharge Characteristics In Different Solid And Gaseous Dielectric By Simulation

Study on Modifying the Simulation Model and Computating the Key Parameters of Partial Discharge in Single Void

The Contribution of Discharge Area Variation to Partial Discharge Patterns in Disc-Voids

Study Of The Influence Of Void Defect Size On Partial Discharge Characteristics In Solid Insulation

The effect of discharge area variation on stochastic characters of PD magnitude

Correlation Between Light Emission Intensity and Partial Discharge Magnitude in Voids

Computer Simulation Of Partial Discharge In Void

Research on the micro-void discharge in power frequency and high frequency

Variation of surface charge distribution in PD sequences

Excess Current Characteristics of Typical Insulation Defects Partial Discharge under 50Hz

Dynamic Behavior of Surface Charge Distribution During Partial Discharge Sequences

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator

Numerical Modeling of Partial Discharges in a Solid Dielectric-bounded Cavity: A Review

Effect of Artificial Void Area on Partial Discharge Characters

Partial Discharge Behaviors Excited by High-Frequency Square Pulse Voltage in Cast Resin Insulation with Thermal-Induced Defect

Study on Simulation Technology of Partial Discharge in Single Void Based on SIMULINK