Abstract:Partial discharge (PD) is a common phenomenon in high voltage (HV) equipment, which will radiate light signals outward in the process of discharge, by detecting this optical signal, we can judge whether the HV equipment have PDs or not, the conventional detection methods under impulse voltage are very complex due to the interference of electromagnetic (EM) wave, but optical method does not have this problem. Fluorescent optical fiber is not affected by numerical aperture problem, so the sensitivity of fluorescent optical fiber sensor is much higher than that of traditional quartz optical fiber sensor. In this work, the fluorescent optical fiber sensor was manufactured and applied to the PD detection in gas insulated switch (GIS) and transformer, fluorescent optical fiber was used as a probe, which was connected with the transmission optical fiber by coupler, and the photomultiplier tube was used to convert the optical signal into electrical signal for displaying by oscilloscope. The discharge signal can be detected by the sensor when the impulse voltage was applied to the GIS and transformer, and it was less affected by the interference of EM wave signals. As the PD source at different positions in GIS, we found that the optical signal attenuates greatly when the optical was blocked by some internal structures, and the attenuation was increase with the increase of distance between PD source and the sensor. The optical signals of PDs can also be detected by the sensor in the transformer, but the attenuation of the optical signal in the transformer was greater than that in GIS, it was greatly affected by the blocking of windings. The two experiments were verified in the TracePro simulation software, and the average deviations between results of experiments and simulations were less than 10%.

Simulation Study on Propagation Characteristics of Optical Signal of Different Partial Discharge Defects

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Propagation Attenuation Properties of Partial Discharge in Typical In-Field GIS Structures

Simulation Analysis on the Propagation of the Optical Partial Discharge Signal in I-shaped and L-shaped GILs

Analysis Of The Intrinsic Characteristics Of The Partial Discharge Induced By Typical Defects In Gis

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

Correction of the Relationship Between Opticalelectrical Signal and Charge Quantity in Partial Discharge Combined Detection

Detection of Partial Discharge in GIS and Transformer Under Impulse Voltage by Fluorescent Optical Fiber Sensor

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator

The Study on a New Method for Detecting Corona Discharge in Gas Insulated Switchgear

The application of fluorescent optical fiber in partial discharge detection of Ring Main Unit

The Characteristics and Detection of the Partial Discharge Induced by the Micro Cracks in GIS Insulators

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Application of a Partial Discharge Diagnosis Method Based on the Novel Multispectral Array Sensor and GMM in Different Insulating Gases

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Partial Discharge Detection of Insultors in GIS: Effectiveness and Limitation

Passive Wireless Partial Discharge Sensors with Multiple Resonances

PD Signal Detection Model Based on Multiscale Simulation of EM Generation and Transmission.

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Optical Characteristics and Fault Diagnosis of Partial Discharge in C4F7N/CO2 Gas Mixture and SF6 Based on Novel Multispectral Microarray Detection

Propogation Characteristics of PD‐induced UHF Signal in 126 Kv GIS with Three‐phase Construction Based on Time–frequency Analysis