Abstract:In this paper, a 220kV GIS bus bar model is established to study partial discharge characteristics of floating electrode defect in Gas Insulated Switchgear (GIS), which is one of the common sources of PD. The 220kV GIS bus bar cavity is taken as an object to design physical model of floating electrode defect. The PD development process is researched by applying gradually increased voltage. The UHF method and the acoustic method are used to detect the PD. The PRPD patterns at different voltage levels of PD are accessed through the PD data of UHF signal. The discharge patterns of different voltage levels at continuous mode and phase mode are obtained through ultrasonic method. These measurements can provide test basis for the assessment of partial discharge provoked by floating electrode defect in GIS. It is shown by experiments that the PD characteristics change as the applied voltage raised. Their specific performances are the discharge number at positive and negative half cycle getting more, and the phase interval gradually widened with the increase of applied voltage. But the discharge amplitude has no dramatic change with the increase of the applied voltage. By comparison of the UHF method and the acoustic method, it is concluded that UHF method has advantages of interference immunity, high sensitivity. The acoustic method is electromagnetic noise immunity. The acoustic sensor do not require intrusive installation and do not destroy the GIS structure itself. Compared to the UHF sensor, it may be more cost effective. But the acoustic signal is attenuated and the measurement sensitivity is under the influence of the temperature. The two methods both can make PD location using the time difference of the different sensors. The two kinds of measurements can provide test basis for the assessment of partial discharge provoked by floating electrode defect in GIS.

Investigation of Partial Discharge Characteristics inside Vacuum Interrupter with Various Floating Shield Potentials

Partial Discharge Characteristics in a Vacuum Interrupter under Different Shield Potentials

Interdependence of Pressure and Shield Potential in Interrupter of Vacuum Circuit Breaker

Discharge pattern discrimination in vacuum interrupter with non-contact measurement of shield potential

Discharge characteristics and mechanisms under the medium vacuum region in a vacuum interrupter

On the Relationship Between Internal Pressure and Permittivity in the Interrupter of VCB

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator

Experimental Investigation on the Interruption Performance of Vacuum Interrupters in a Quench Protection Switch

Discharge Path Measurement of A Vacuum Interrupter with Fixed Break after Suffering High Inrush Current

Optical Diagnostics of Vacuum Arc in the process of DC Interruption

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Influence of the vapor shield potential control on the post-arc sheath development in vacuum interrupters

Effect of Gassing Material on Partial Discharge Characteristics in MCCB

Prediction Method of Breakdown Voltage Probability Distribution Considering Area Effect for Shield Gaps in Vacuum Interrupter

Study Of The Influence Of Void Defect Size On Partial Discharge Characteristics In Solid Insulation

Study on the Radial Dissipation of Residual Plasma in Vacuum Circuit Breaker with a Two-Dimensional Particle-In-Cell Model

Partial discharge characteristics of void defect in SF6 under stepped AC voltage

Experimental Investigation on the Interruption Performance of Vacuum Interrupters With AMF and TMF Contacts in a Quench Protection Switch

Research on the Reignition Problem and Interruption Characteristics of Series Connected Vacuum Interrupters

Measurement and Analysis of Partial Discharge on Floating Electrode Defect in GIS

A Novel Approach to Partial Discharge Detection Under Repetitive Unipolar Impulsive Voltage