Abstract:The objective of this paper is to determine how the high-voltage discharging metal vapour deposited on the nearby ceramic inner surface influences the breakdowns of gaps between centre shield and end shield in vacuum interrupters. Two types of shield materials were selected, namely copper and stainless steel. The end curvature radius of the shield was 3 mm. The distance between the shields could adjust manually from 4 to 8 mm. The distance between the shields and ceramic was 3.5 mm. The negative polarity standard lightning impulse voltage (12/50 μs) was repeated for 900 operations based on an up-and-down method. The experimental results illustrated that the metal deposition layer on the inner surface of the ceramic envelope significantly influenced the breakdown voltage of the shield gaps. At a shield gap distance of d = 4 mm, the breakdown voltage of the shield gap increased from an initial lower voltage to the saturation voltage by approximately 200 operations. Then, the breakdown voltage decreased to a lower voltage range during only 50 operations, and the breakdown voltage maintained at this lower voltage range until the end of 900 operations. Furthermore, as the shield gap distance increased from d = 4 to 6 mm and 8 mm, the breakdown voltage also maintained at this lower voltage range. A metal deposition layer was formed on the inner surface of ceramic by repetitive application of the lightning impulse voltage. To analyse the influence of the metal deposition layer, the electric field distributions were calculated for the original vacuum interrupter and the vacuum interrupter with the metal deposition layer on the ceramic inner surface. The simulation results suggested that the metal deposition layer took part in the breakdown path between the shield gaps and deteriorated the insulation performance.

Interdependence of Pressure and Shield Potential in Interrupter of Vacuum Circuit Breaker

On the Relationship Between Internal Pressure and Permittivity in the Interrupter of VCB

Influence of the vapor shield potential control on the post-arc sheath development in vacuum interrupters

Breakdown of shield gaps in vacuum interrupters

Breakdown voltage of electrode arrangements in vacuum circuit breakers

Investigation of Partial Discharge Characteristics inside Vacuum Interrupter with Various Floating Shield Potentials

Pressure Measurement and Characteristic Analysis on a 252-Kv Puffer-Type SF $_{6}$ Circuit Breaker

Interrupter Pressure Measurement of a 252 Kv SF6 Circuit Breaker

Pressure Distribution Along The Nozzle Of A Hv Sf6 Circuit Breaker

Vapor shield potential in vacuum interrupters after clearing of short circuits

Partial Discharge Characteristics in a Vacuum Interrupter under Different Shield Potentials

Vacuum Circuit-Breaker Parameter Calculation and Modelling for Power System Transient Studies

Research on the Influence of Current Limiter Based on Highly Coupled Split Reactor on Main Circuit Breaker Overvoltage

Lightening Impulse Breakdown of Vacuum Gaps in Series—Part I: Partial Breakdown

Three-phase Modeling of Vacuum Circuit Breakers Switching off Shunt Reactors

Study of Arc Interruption Characteristics under Rated Current in Low Voltage Circuit Breakers

Study on the Mathematical Model of Dielectric Recovery Characteristics in High Voltage Sf6 Circuit Breaker

Influence of residual plasma drift velocity on the post-arc sheath expansion of vacuum circuit breakers

Current distribution and power loss within the sliding contact structure of vacuum circuit breaker

Lightening Impulse Breakdown of Vacuum Gaps in Series—Part II: Bridging Resistor

Study on impact of gap difference on plasma distribution of direct current vacuum circuit breaker with double-break