Abstract:The objective of this paper is to determine how the high-voltage discharging metal vapour deposited on the nearby ceramic inner surface influences the breakdowns of gaps between centre shield and end shield in vacuum interrupters. Two types of shield materials were selected, namely copper and stainless steel. The end curvature radius of the shield was 3 mm. The distance between the shields could adjust manually from 4 to 8 mm. The distance between the shields and ceramic was 3.5 mm. The negative polarity standard lightning impulse voltage (12/50 μs) was repeated for 900 operations based on an up-and-down method. The experimental results illustrated that the metal deposition layer on the inner surface of the ceramic envelope significantly influenced the breakdown voltage of the shield gaps. At a shield gap distance of d = 4 mm, the breakdown voltage of the shield gap increased from an initial lower voltage to the saturation voltage by approximately 200 operations. Then, the breakdown voltage decreased to a lower voltage range during only 50 operations, and the breakdown voltage maintained at this lower voltage range until the end of 900 operations. Furthermore, as the shield gap distance increased from d = 4 to 6 mm and 8 mm, the breakdown voltage also maintained at this lower voltage range. A metal deposition layer was formed on the inner surface of ceramic by repetitive application of the lightning impulse voltage. To analyse the influence of the metal deposition layer, the electric field distributions were calculated for the original vacuum interrupter and the vacuum interrupter with the metal deposition layer on the ceramic inner surface. The simulation results suggested that the metal deposition layer took part in the breakdown path between the shield gaps and deteriorated the insulation performance.

Vapor shield potential in vacuum interrupters after clearing of short circuits

Interdependence of Pressure and Shield Potential in Interrupter of Vacuum Circuit Breaker

Influence of the vapor shield potential control on the post-arc sheath development in vacuum interrupters

Breakdown of shield gaps in vacuum interrupters

Partial Discharge Characteristics in a Vacuum Interrupter under Different Shield Potentials

Recovery of breakdown strength of a vacuum interrupter after extinction of high currents

Physics of high-current interruption of vacuum circuit breakers

Measurement of Electrode Surface Temperature and Post-Arc Current in Vacuum Interrupter

Discharge pattern discrimination in vacuum interrupter with non-contact measurement of shield potential

Investigation of Partial Discharge Characteristics inside Vacuum Interrupter with Various Floating Shield Potentials

Research On Post-Arc Reignition Phenomena For 40.5kv Vacuum Interrupter

Study of initiation of vacuum arcs

Discharge Path Measurement of A Vacuum Interrupter with Fixed Break after Suffering High Inrush Current

Charging potential measurement of floating electrode modeled on the arc shield of vacuum interrupter under AC voltage application

Research on the current-zero period of vacuum arc interruption and equivalent model of post-arc gap

Distribution of Electric Field in Vacuum Interrupter During Interrupting

Dielectric recovery behaviors after low current interruption measured by submicrosecond voltage impulses

Dielectric Recovery Strength after Vacuum Arc Extinctions

Study on the Proportions of Charged Particles Absorbed by Post-Arc Anode in the Post-Arc Phase of a Vacuum Circuit Breaker

Post-arc Current Measurement and Interruption Performance of Vacuum Interrupter in DC Interruption

The Effect and Dynamic Behavior of Particles in High-Current Vacuum Arc Interruptions