Abstract:In a switchgear, an external transverse magnetic field (ETMF) is generated by the U type loop consisting of the vacuum interrupter, external busbar and conductive rod connected to the vacuum interrupter. The ETMF will make the vacuum arc deflected and strengthen the contraction of the arc. This can increase the probability of breaking failure. To weaken the adverse effect of the ETMF, the real magnetic field data of the arc area with different structure parameters when the length of conductive rod, external busbar and phase distance is changed are obtained by establishing simulation model in this paper. Taking the real magnetic field data as the boundary condition, this paper obtains the typical parameters of the vacuum arc plasma with different structure parameters by using the established three-dimensional high-current vacuum arc magnetohydrodynamics model. The simulation results show that the ETMF makes the transverse magnetic field (TMF) of the arc area asymmetric, which leads to an arc deflection. Reducing the length of the conductive rod connected to the vacuum interrupter to 50 mm can effectively improve the asymmetry of the TMF caused by the EMTF, weaken the arc deflection phenomenon, make the distribution of the plasma parameters more uniform, and increases the utilization of the anode contact surface. Moreover, it can not only reduce the heat flux density into the anode as a whole, but also reduce the heat flux density in the high heat flux density area, so as to effectively reduce the degree of anode activity and improve the negative effects caused by the anode activity. The changes of other external structural parameters have less influence on the improvement of the vacuum arc deflection phenomenon. Increasing the phase spacing to 275 mm or reducing the length of the external bus bar to 100 mm can only slightly weaken the arc deflection.

Three-phase Modeling of Vacuum Circuit Breakers Switching off Shunt Reactors

Three-phase Modeling of 40.5-Kv Vacuum Circuit Breaker Switching off Shunt Reactors and Overvoltage Suppression Measure Analysis

Simulation Of Breaking Characteristics Of A 550 Kv Single-Break Tank Circuit Breaker

Simulation Research on the Post-arc Dielectric Recovery Characteristics of Multi-break Vacuum Circuit Breakers

Vacuum Circuit-Breaker Parameter Calculation and Modelling for Power System Transient Studies

Study Of The Dissipation Of Residual Plasma With A One-Dimensional Particle-In-Cell Model In A Vacuum Circuit Breaker

3D Hybrid Simulation of Postarc Sheath Expansion with Nonuniform Residual Plasmas

Dynamic fault analysis model development for vacuum circuit breaker action

Modeling and Simulation of ±10 Kv DC Transmission System Based on Mechanical DC Circuit Breaker

Numerical Research on Switching Arc of Circuit Breaker

Overvoltage Mechanism of Switching off Shunt Reactors for 40.5kV Vacuum Circuit Breakers

Simulation of Arc Characteristics in Miniature Circuit Breaker

Study of Arc Interruption Characteristics under Rated Current in Low Voltage Circuit Breakers

Topology, Modeling and Transient Current Transfer Analysis of DC Hybrid Vacuum Circuit Breaker Based on SiC Module

Numerical Simulation of Vacuum Arc Behavior Considering Action of Adjacent Phases in Vacuum Circuit Breakers

3D Modeling and Simulation of High-Current Vacuum Arc Subjected to Real External Transverse Magnetic Field

Numerical Investigation on the Influence of Circuit Breaker Structure Parameters on Vacuum Arc Behaviors

Overvoitage of Shunt Reactor Caused by Prebreakdown of SF6 Breaker and Protection Measures

Post-arc current simulation based on measurement in vacuum circuit breaker with a one-dimensional particle-in-cell model

Fault Arc Modeling and Analysis in Circuit Breaker in HVDC Converter Station Filter Branch

Simulation analysis of the 126kV three-break vacuum circuit breaker with phase-control method used in capacitive interrupting