Abstract:This research delves into the primary issue of polyimide (PI) insulation failures in high-frequency power transformers (HFPTs) by scrutinizing partial discharge development under high-frequency electrical stress. This study employs an experimental approach coupled with a plasma simulation model for a ball–sphere electrode structure. The simulation model integrates the particle transport equation, Poisson equation, and complex chemical reactions to ascertain microscopic parameters, including plasma distribution, electric field, electron density, electron temperature, surface, and space charge distribution. The effect of the voltage polarity and electrical energy on the PD process is also discussed. The contact point plays a pivotal role in triggering partial discharges and culminating in the breakdown of PI insulation. Asymmetry phenomena were found between positive and negative half-cycles by analyzing the PD data stage by stage. A significant number of PDs increased at every stage and the PD amplitude was higher during the negative cycle at the initial stage, but in later stages, the PD amplitude was found to be higher in the positive half-cycle, and scanning electron microscopy (SEM) revealed that the maximum damage occurred near the contact point junction. The simulation results show that the plasma initially accumulates the electron density near the contact point junction. Under the action of the electric field, plasma starts traveling at the PI surface outward from the contact point. Before the PD activity, all parameters have higher values in the plasma head. The microscopic parameters reveal maximum values near the contact point junction, during PD activities where significant damage takes place. These parameter distributions exhibit a decreasing trend over time as when the PD activity ends. The model's predictions are consistent with the experimental data. The paper lays the foundation for future research in polymer insulation design under high-frequency electrical stress.

The influence of cavity's parameters within polyimide material on partial discharge

Study On The Partial Discharge Characteristics In Different Solid And Gaseous Dielectric By Simulation

Characterization of cavities in polyetherimide and the influence on insulation performance of ultra-high voltage pulse

Size Effect of Partial Discharge in Solid Void Defects

Influence of Interfacial Contact Morphology on High Frequency Breakdown Strength and Partial Discharge Characteristics of Epoxy-Polyimide

Investigation of Partial Discharge Transformation Characteristics in Polyimide (PI) Insulations under High-Frequency Electric Stress

Frequency-Induced Inflection Point Phenomenon and Formation Mechanism of Partial Discharge with Polyimide Films

The Influence Of Voltage-Sensitive Additive On Electrical Parameters Of Polyimide

Effects of Partial Discharge under Square Pulse Voltage on Lifetime of Polyimide Film

Cavity and Interface Effect of PI-Film on Charge Accumulation and PD Activity under Bipolar Pulse Voltage

Influences of Internal Void Defect Dimension and Position on Partial Discharge Characteristics in the Solid Insulation

Influencing Factors on Characteristics of Partial Discharge in Void of Insulating Materials

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Study Of The Influence Of Void Defect Size On Partial Discharge Characteristics In Solid Insulation

Thickness-Dependent DC Electrical Breakdown of Polyimide Modulated by Charge Transport and Molecular Displacement

Modelling of Enhancement of Electric Field and Temperature on Partial Discharge in the XLPE Cavity Model under Positive DC Voltage

Investigation on Combined Effect of Humidity–temperature on Partial Discharge Through Dielectric Performance Evaluation

Numerical Modeling of Partial Discharges in a Solid Dielectric-bounded Cavity: A Review

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

Partial Discharge Characteristics of Cavities with Different Appearances and Positions in Solid Insulation

Electrical Damage Characteristics of Polyimide Film Caused by Surface Discharge