Abstract:The compact design of the cast resin high-frequency transformers (HFTs) allows the insulation of fine structures withstand severe high-frequency square pulse voltage stress and thermal stress. The partial discharge (PD) behaviors in the presence of thermal-induced defects are investigated. The phase-resolved PD (PRPD) pattern showed that the majority of PDs occurs on the rising and falling edges of the square pulse voltage. The PD inception voltage (PDIV), PD magnitude, and PD repetition rate increase with frequency at very low frequency and decrease with frequency at high frequency. Long charge injection time at very low frequency and the heat effect at high frequency cause the diminution of these PD parameters. The PD and breakdown characteristics are examined under progressive temperature conditions, indicating an early PD degradation and electrical failure phenomenon below the glass transition temperature (T-g). Microscopic observation revealed the formation of delamination gap defects due to the inconsistency of thermal expansion between the cast insulation and metal, which considered the cause of PDs. The decohesion model is employed to describe the structural evolution and the formation of delamination gap with varying temperatures. The model demonstrates an early damage mechanism for interfacial cohesion condition at medium temperatures and temperatures close to T-g . Additional experiment enables the inference that the release of local interfacial stress under progressive temperature may lead to the formation of damaged interfaces or microcracks, which can trigger occasional PD or instantaneous filamentary breakdown.

Influencing Factors on Characteristics of Partial Discharge in Void of Insulating Materials

Study Of The Influence Of Void Defect Size On Partial Discharge Characteristics In Solid Insulation

Critical Study of Partial Discharge Inception in Voids: Statistical Behavior to Stochastic Nature

Size Effect of Partial Discharge in Solid Void Defects

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Effect of Artificial Void Area on Partial Discharge Characters

Variation of Surface Charge Distribution in the Process of PD Degradation

Study On The Partial Discharge Characteristics In Different Solid And Gaseous Dielectric By Simulation

Characteristics and Mechanism of Partial Discharge Behavior of Power Module Under Unipolar Square Voltage

The effect of discharge area variation on stochastic characters of PD magnitude

The Contribution of Discharge Area Variation to Partial Discharge Patterns in Disc-Voids

Study on the Characteristics of Partial Discharges in Voids under Square Voltage by Detecting Light Emission Intensity

Influences of Internal Void Defect Dimension and Position on Partial Discharge Characteristics in the Solid Insulation

Partial Discharge Behaviors Excited by High-Frequency Square Pulse Voltage in Cast Resin Insulation with Thermal-Induced Defect

The influence of cavity's parameters within polyimide material on partial discharge

Study on Modifying the Simulation Model and Computating the Key Parameters of Partial Discharge in Single Void

Partial Discharge Development in Needle-Plane Configuration of Oil-Paper Insulation under AC Voltage

Variation of surface charge distribution in PD sequences

Influence of Void Dimensions on Partial Discharge in Solid Insulation

Influence of Temperature on Partial Discharge Characteristics in Disc-Void of Oil/Pressboard Insulation

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator