Abstract:The compact design of the cast resin high-frequency transformers (HFTs) allows the insulation of fine structures withstand severe high-frequency square pulse voltage stress and thermal stress. The partial discharge (PD) behaviors in the presence of thermal-induced defects are investigated. The phase-resolved PD (PRPD) pattern showed that the majority of PDs occurs on the rising and falling edges of the square pulse voltage. The PD inception voltage (PDIV), PD magnitude, and PD repetition rate increase with frequency at very low frequency and decrease with frequency at high frequency. Long charge injection time at very low frequency and the heat effect at high frequency cause the diminution of these PD parameters. The PD and breakdown characteristics are examined under progressive temperature conditions, indicating an early PD degradation and electrical failure phenomenon below the glass transition temperature (T-g). Microscopic observation revealed the formation of delamination gap defects due to the inconsistency of thermal expansion between the cast insulation and metal, which considered the cause of PDs. The decohesion model is employed to describe the structural evolution and the formation of delamination gap with varying temperatures. The model demonstrates an early damage mechanism for interfacial cohesion condition at medium temperatures and temperatures close to T-g . Additional experiment enables the inference that the release of local interfacial stress under progressive temperature may lead to the formation of damaged interfaces or microcracks, which can trigger occasional PD or instantaneous filamentary breakdown.

Study Of The Influence Of Void Defect Size On Partial Discharge Characteristics In Solid Insulation

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Influences of Internal Void Defect Dimension and Position on Partial Discharge Characteristics in the Solid Insulation

Size Effect of Partial Discharge in Solid Void Defects

Influence of Void Dimensions on Partial Discharge in Solid Insulation

Partial Discharge Characteristics of a Void Defect inside an Actual 252-kV GIS Post Insulator

Research on the Statistical Characteristics of the Discharge Inception Electric Field Strength of Gap Defect in Insulation Pressboard Based on Three-parameter Weibull Model

Influencing Factors on Characteristics of Partial Discharge in Void of Insulating Materials

Partial Discharges in Void Defect of Gas Insulated Switchgear Insulator under Standard Aperiodic and Oscillating Switching Impulses

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Insulating Void Defect Analysis Of Onsite 252kv Gis By Employing Partial Discharge Uhf Diagnosis And Industry Ct

Measurement of partial discharge pattern on typical defects in GIS

Study on the Partial Discharge Characteristics and Development Process in Use of the Multiple Discharge Patterns for the Typical Defects in Gas-Insulated Switchgear

Measurement and Simulation of Partial Discharge in Disc-void of Oil-pressboard Insulation With Electrical Degradation Process

Study On The Partial Discharge Characteristics In Different Solid And Gaseous Dielectric By Simulation

Research on the micro-void discharge in power frequency and high frequency

Partial Discharge Characteristics of Cavities with Different Appearances and Positions in Solid Insulation

Partial Discharge Behaviors Excited by High-Frequency Square Pulse Voltage in Cast Resin Insulation with Thermal-Induced Defect

Study on Modifying the Simulation Model and Computating the Key Parameters of Partial Discharge in Single Void

Partial discharge characteristics of void defect in SF6 under stepped AC voltage

The Characteristics and Detection of the Partial Discharge Induced by the Micro Cracks in GIS Insulators