Abstract:Detection of partial discharge (PD) is an effective technical means to discover the sudden and developing insulation defects. PD is accompanied by a variety of transient physical phenomena, which are essentially the proliferation, disappearance and transfer of charge in the process of ionization. The current coupled in the circuit is an important indicator of the discharge. Measurement of current pulses developed by such principle has been the standard test method for insulation parts and has become the only criterion for calibrating the discharge capacity. However, the broadband measurement is insensitive to the low-frequency current, thus cannot detect the electric field-drive behavior of the slow charges generated by the PDs. To research the slow charge dynamic during PD, a narrowband measurement of detecting the excess current induced by PD is used in this work, and considering the horizontal and vertical path for the PD-induced current, a tri-electrode system is designed for dividing the current into the surface and the bulk part. Excess current is the current accompanying PD activities, which can be quantified by measuring the dielectric response current flowing through the defect before and during PD. The principle is based on the assumption that the capacitive current is proportional to the voltage. By canceling (removing) the capacitive current during the PD process, an excess current purely related to the PD is obtained. The experimental results show that the low frequency current which cannot be detected by the pulse current method does exist in the PD process. The amplitude of the excess current waveform is higher than the average discharge current, and the phase distribution is a little wider than the latter. The discharge quantity of the positive and negative current of the excess current is higher than that of the PD pulse current. The analysis of the net excess current reflects the current characteristics of the slow moving charge in the PD process. Through waveform analysis and geometric capacitance measurement, it can be seen that the presence of geometric capacity will have a large impact on the measurement of surface current.

Measurement of Excess Current Accompanying Partial Discharge of Polymer Film in Tri-electrode System under Power Frequency Voltage

Excess Current Characteristics of Typical Insulation Defects Partial Discharge under 50Hz

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

Slow Current Induced by Partial Discharge in Kapton, Epoxy and PET

Characteristics of the Partial Discharge-induced Current along Epoxy Resin Film under Superimposed AC-DC Voltage

Excess conduction induced by partial discharge in polymer

Variation of surface charge distribution in PD sequences

High Sensitive DCPD Measurement and Analysis System of High-Voltage Storage Capacitor

Electric Field Measurement in the Process of Partial Discharge Using Electric Field Induced Second Harmonic Generation

Partial Discharge Investigation under Humidity Conditions Via Dissipation Factor and Insulation Capacitance Tip-Up Test

The Measurement System of Partial Discharge under Impulse Voltage

Measurement of DC Partial Discharge of High-voltage Storage Capacitor

Partial discharge detection on power equipment using a magneto-resistive sensor

Dynamic Behavior of Surface Charge Distribution During Partial Discharge Sequences

High Bandwidth Measurement Of Partial Discharge Current Pulses Based On The Optimized Needle-Plate Electrode System

A Technique to Identify the Types of Partial Discharges

Partial Discharge Signals Separation Using Cumulative Energy Function and Mathematical Morphology Gradient

Measurement and Analysis for Pulse Current Shapes of Partial Discharge in Oil under DC Voltage

Self-adaptive Separation of Multiple Partial Discharge Sources Based on Optimized Feature Extraction of Cumulative Energy Function

Measurement and analysis for pulse sequence of partial discharge signals under DC voltage