Abstract:Using the real-time microscopy digital imaging and partial discharge(PD) continuous measuring system,we studied the electrical tree shape properties,initiation,growth law,as well as PD characteristics in 110 kV cross-linked polyethylene(XLPE) power cable insulation under different applied voltages at high temperature by the typical needle-plane electrode geometry.The experimental results indicated that the effect of temperature on the shape,initiation and growth time of the typical electrical trees in XLPE cable insulation was dominant.The electrical tree shapes displayed the features of diversity under different stressing voltages at an elevated temperature.The typical tree shapes at 50°C are branch tree,branch-pine tree and bush tree.The trees at 70°C are branch trees,and the trees at 90°C are stagnation-type tree and branch tree.The electrical tree initial time declined with the increase of the applied voltages,and decreased with the increase of the temperature at the same applied voltage,which was due to the melting of the lamella in XLPE cable insulation at high temperatures,and the increase of the amorphous regions and free volumes in dielectrics.It was found that the electrical tree growth rate at low voltage(9 kV) declined due to the increase of the tree channel conductivity,which suppressed the PD activity in the tree structure.The tree growth rate decreased with higher fractal dimension.However,the electrical trees grew rapidly to the counter electrode in branch-type with the continuous PD activity under higher applied voltages(≥11 kV).Meanwhile,the elastic modulus of XLPE decreased at high temperatures,the dielectric strength declined,the effect of PD activity was fiercer,which accelerated greatly the electrical tree growth at high temperatures,and the fractal dimension of the tree was lower.

Effect of Waveform Parameters of High Voltage Square-wave Pulse on Partial Discharge

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Propagation and Partial Discharge Characteristics of Electrical Trees in 110 Kv XLPE Cable Insulation at Power Frequency Applied Voltage

Influence of AC and DC Voltage Superposition on Partial Discharge of Composite Insulator

Effect of Test Voltage Waveforms on Partial Discharge Inception Voltage Considering Different Environmental Conditions

TYPICAL PULSE SHAPE AND FREQUENCY CHARACTERISTIC OF THE PD SIGNAL IN OIL-PAPER INSULATION

Characteristics and Mechanism of Partial Discharge Behavior of Power Module Under Unipolar Square Voltage

Study on waveform characteristics of partial discharge pulses in air

Considering the Parameters of Pulse Width Modulation Voltage to Improve the Signal-to-Noise Ratio of Partial Discharge Tests for Inverter-Fed Motors

Effect of Temperature on Partial Discharge Properties of Polyimide Film Under Continuous Square Impulse Voltage

Development of partial discharge in oil-impregnated insulation and its effect

Feature Extraction And Comprehension Of Partial Discharge Characteristics In Transformer Oil From Rated Ac Frequency To Very Low Frequency

Impact of impulse voltage frequency on the partial discharge characteristic of electric vehicles motor insulation

Pd Pulse Burst Characteristics in Differently Aged Transformer Oils under Ac Conditions

Degradation Diagnosis of Large Stator Winding Insulation Based on Ultra-Wide Band Partial Discharge Detecting Technique

Study on the Influence of Pulse Propagation in Transformer Winding on Partial Discharge Pattern Recognition

A Review of Partial Discharge in Stator Winding of Rotating Machines Fed by Voltage Source PWM Motor Drives

Partial Discharge Initiating Process of Transformer Oil under Combined AC and DC Voltage

Review of Partial Discharge Activity Considering Very-Low Frequency and Damped Applied Voltage

Measurement and Simulation of Partial Discharge in Oil-Paper Insulation under the Combined AC–DC Voltage

Propagation Characteristics of Partial Discharge Pulses in the Cable