Abstract:The inverter-fed motor is a key component of environmental-friendly hybrid cars, high-speed trains, and other industrial applications. After the widespread use of inverter-fed motors, the repetitive impulse surges from inverters were found to cause new insulation problems in inverter-fed motors that were linked to premature insulation failure. The partial discharge (PD) induced by the overvoltage inner stator windings was found to be the root cause of insulation reliability problems. To mitigate this problem, PD detection and life testing at repetitive square voltages should be performed on new types of insulation models and entire motor insulation systems. The obtained partial discharge inception voltage (PDIV) and lifetime of insulation in the tests can be used to evaluate the insulation status of inverter-fed motor insulation systems and thus to improve the insulation designs. At AC voltage conditions, the voltage frequency can significantly affect PD activity. At repetitive square voltage with rapid rise time, the influence of the square voltage frequency on PD activity should be investigated (1) to suggest values for the repetitive square voltage frequency selection for the PDIV and lifetime tests, and (2) to increase the signal-to-noise ratio when extracting PD pulses from strong disturbances generated by the operating switch of impulse generators. Therefore, the main purpose of this paper was to investigate the effects of repetitive square voltage frequency on PD events. Insulation models of both Type I (low-voltage inverter-fed motor) and Type II (high-voltage inverter-fed motor) were used to obtain single-PD and multi-PD statistical features, respectively. Experimental results indicated that higher frequencies caused less PD events with lower PD magnitudes and shorter delay times in one square voltage cycle. This phenomenon was attributed to the different surface charge decay ratios and the initial electron emission probabilities resulting from different square voltage frequencies. Finally, a number of considerations for PD measurements on inverter-fed motors were provided to improve the sensitivity of the PD test system and to obtain high objective insulation lifetime test results, which are used to assess the insulation status of inverter-fed motors.

Considering the Parameters of Pulse Width Modulation Voltage to Improve the Signal-to-Noise Ratio of Partial Discharge Tests for Inverter-Fed Motors

Partial Discharge Characteristics of Inverter-fed Motor Insulation at Repetitive Square Wave Voltages

Study of Partial Discharge Characteristics at Repetitive Square Voltages Based on UHF Method

Effect of Repetitive Square Voltage Frequency on Partial Discharge Features

Measurement of Partial Discharge of Winding in SPWM Inverter-Fed Induction Motors

Measurement and Analysis of Partial Discharge under High Voltage Continuous Impulses for Inverter-fed Insulation

Characterizations of Partial Discharge in Modern Power Electronics

New Tools To Determine The Partial Discharges Of Inverter Fed Motor

A Review of Partial Discharge in Stator Winding of Rotating Machines Fed by Voltage Source PWM Motor Drives

Comparison of Partial Discharge Characterizations under 60 Hz Sinusoidal Waveform and High-frequency PWM Waveform

Partial Discharge Extraction Under PWM Pulse by sym4 Wavelet Digital Filter

Characterization of Partial Discharges in High-Frequency Transformer under PWM Pulses

Effect of Waveform Parameters of High Voltage Square-wave Pulse on Partial Discharge

Inverter-Embedded Partial Discharge Testing for Reliability Enhancement of Stator Winding Insulation in Low Voltage Machines

Phase Distribution Characteristics of Partial Discharge under Square Pulse Voltage

Partial Discharge Detection and Assessment of Surface defects under Fast Rising Repetitive Square Voltage for MV Converter Application

Insulation Failure of Inverter-fed Motors and Partial Discharge Detection Technology under Repetitive Square Wave Voltage

Characteristic Research on the Sensor for Inter-turn Partial Discharge Measurement of Inverter-fed Motor Winding

Study on the feasibility of detection of partial discharge signals under square voltages

Techniques for off-line measurement and analysis of PD pulses in inverter-fed induction motors

Effect of Test Voltage Waveforms on Partial Discharge Inception Voltage Considering Different Environmental Conditions