Abstract:Although adjustable-speed drives (ASDs) with induction machines (IMs) have already evolved as a mature technology, accurate encoderless operation at very low speed range remains to be problematic for all existing control methods, which include nonlinearity compensation, model-reference-adaptive-system (MRAS), various types of observers, high frequency injection leveraging saliency effects, artificial intelligence (AI) or neural network techniques. These encoderless solutions are integrated into either direct torque control (DTC), or stator current regulated pulse-width-modulated (CRPWM) controllers. The DTC solution can have better dynamic responses, while the CRPWM regulator provides superior steady state performances. In the category of observer formulations without signal injection, one promising dual frame sliding mode observer (DFSMO) can achieve a published performance of below 6 revolutions per minute (rpm) (0.2Hz) at full load under a DTC scheme. DFSMO does not need the rotor position or rotor flux angle, thus it increases the estimation accuracy and is tolerable to IM parameter variations and disturbances. Even though DTC schemes have been researched more in recent years, the rotor flux orientated vector control (RFOVC) architecture still dominates industrial applications. In this paper, instead of DTC, a DFSMO is developed under the RFOVC architecture which cannot be found in published literatures to demonstrate its transient and steady-state low speed performances at both motoring and regenerating mode. Analytical, simulation studies are presented and verified through a 3hp (2.2kW), 380V, 50Hz IM ASD experimental system. © 2012 IEEE.

Performance Characterization of Random Pulse Width Modulation Algorithms in Industrial and Commercial Adjustable-Speed Drives

Research on PWM Method in Brushless DC Motor

Adjustable Speed Drives and Power Quality: Challenges and Cost-Effective Opportunities

Performance Analysis of Asynchronous PWM at Low Carrier Ratios

A Multipulse Pattern Modulation Scheme for Harmonic Mitigation in Three-Phase Multimotor Drives

Quantitative System Compatibility and Characteristics Analysis of Two-Level and Three-Level Low Voltage Industrial Drives

Generalized N-State Random Pulse Position Discontinuous PWM for High-Frequency Harmonics Reduction and Performance Improvement at High Modulation Ratios

Slip angle control based DTC of open-end winding induction motor drive using dual randomized decoupled PWM for acoustic noise mitigation in EV application

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Hybrid RPWM Technique Based on Modified SVPWM to Reduce the PWM Acoustic Noise

Selective Noise Suppression Methods Using Random SVPWM to Shape the Noise Spectrum of PMSMs

Quantitative Harmonics Performance Evaluation of High-Speed Permanent Magnet Synchronous Machine under Various Synchronous SVPWM Strategies

Current regulated pulse width modulation controller impact on low speed performances of industrial encoderless adjustable speed drives under sliding mode variable structures

Acoustic Noise Mitigation in Slip Angle Controlled DTC of Open-End Winding Induction Motor Drive Using Dual Randomized AISPWM for EV Application

Carrier-Based Variable Frequency PWM Technique for PMSM Drives to Achieve Dispersed Spectrum and Extended Low-Speed Operation Capability

A Novel Pulse Width Modulation Strategy Used for Permanent Magnet Synchronous Motor Drives

Comparative Study on Single Pulse and Dual Pulses Variable Width Control Strategies for High-Speed PM BLDC Motor Drive

An Improved Type of Synchronized Space Vector PWM Based on Switching Angles for High‐Power AC Drive Application

Characterization and Selection of Probability Density Function in a Discrete Random Switching Period SVPWM Strategy

A Random Pulse Position-Based Selective Noise Cancellation Modulation Method for SVPWM Driven PMSMs

Research on Relations Between Two PWM Technologies and System Performance Optimization