Abstract:In this work, a new methodology is proposed for the online and non-invasive extraction of partial discharge (PD) pulses from raw measurement data obtained using a simplified setup. This method enables the creation of sub-windows with optimized size, each containing a single candidate PD pulse. The proposed approach integrates mathematical morphological filtering (MMF) with kurtosis, a first-order Savitzky-Golay smoothing filter, the Otsu method for thresholding, and a specific technique to associate each sub-window with the phase angle of the applied voltage waveform, enabling the construction of phase-resolved PD (PRPD) patterns. The methodology was validated against a commercial PD detection device adhering to the IEC (International Electrotechnical Commission) standard. Experimental results demonstrated that the proposed method, utilizing an off-the-shelf 8-bit resolution data acquisition system and a low-cost high-frequency current transformer (HFCT) sensor, effectively diagnoses and characterizes PD activity in high-voltage equipment, such as surge arresters and instrument transformers, even in noisy environments. It was able to characterize PD activity using only a few cycles of the applied voltage waveform and identify low amplitude PD pulses with low signal-to-noise ratio signals. Other contribution of this work is the diagnosis and fault signature obtained from a real surge arrester (SA) with a nominal voltage of 192 kV, corroborated by destructive disassembly and internal inspection of the tested equipment. This work provides a cost-effective and accurate tool for real-time PD monitoring, which can be embedded in hardware for continuous evaluation of electrical equipment integrity.

Parallel Diode‐clamped Linear Converter for Withstand Test and Partial Discharge Measurement of Electric Equipment

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

Megahertz ZVS Transformerless Interleaved Inverter for Dielectric Barrier Discharge Lamps

A New ZVCS Resonant Voltage-Fed Push-Pull Converter for Vehicle Inverter Application

A High Efficiency Linear Power Supply with Pure Sine Wave for High Voltage Test

An Integrated Testbed with Single DC Source for Delivering Symmetrical Square-Wave Excitation Voltage in the Triple Pulse Test.

Partial Discharge Characteristics in Oil-Paper Insulation under Combined Ac-Dc Voltage

Measurement and Simulation of Partial Discharge in Oil-Paper Insulation under the Combined AC–DC Voltage

Inverter-Embedded Partial Discharge Testing for Reliability Enhancement of Stator Winding Insulation in Low Voltage Machines

Space-Charge Accumulation and Its Impact on High-Voltage Power Module Partial Discharge Under DC and PWM Waves: Testing and Modeling

Feature Extraction And Comprehension Of Partial Discharge Characteristics In Transformer Oil From Rated Ac Frequency To Very Low Frequency

Design and testing of 45 kV, 50 kHz pulse power supply for dielectric barrier discharges

A Novel Method for Online Diagnostic Analysis of Partial Discharge in Instrument Transformers and Surge Arresters from the Correlation of HFCT and IEC Methods

A Novel Approach to Partial Discharge Detection Under Repetitive Unipolar Impulsive Voltage

Characteristics and Identification of Partial Discharge for Insulation Structures in High Voltage IGBT Modules Under Positive Square Wave Voltage

Considering the Parameters of Pulse Width Modulation Voltage to Improve the Signal-to-Noise Ratio of Partial Discharge Tests for Inverter-Fed Motors

Partial Discharge Detection and Sensitivity Improvement for Bushing Based on Optical Interference Technique

Review of Partial Discharge Activity Considering Very-Low Frequency and Damped Applied Voltage

Novel dual‐resonance damped alternating current testing system for offline partial discharge measurement of power cables

A Novel Oscillation Wave Test System for Partial Discharge Detection in XLPE Cable Lines

Development and Application of DC Partial Discharge Test System