Abstract:This paper investigates the pull-in dynamics of single-sided and double-sided parallel-plate (SSPP and DSPP) structures employed in MEMS devices for acceleration measurement. A lumped electromechanical model considering a variable damping coefficient and external acceleration is developed for studying their pull-in dynamical behavior. The critical pull-in displacement and pull-in voltage for both parallel-plate structures operated with external acceleration are derived based on the static and dynamical analysis of the proposed model, which are in good agreement with the experimental results. The derived closed-form solutions are shown to be capable of predicting the pull-in behavior of both parallel-plate structures in an overdamped system. Two MEMS parallel-plate structures exhibit distinct pull-in characteristics due to their distinct configurations. The commonly used SSPP structure for MEMS devices is shown to have a relatively linear response to the external acceleration in terms of the critical pull-in displacement and pull-in voltage. However, the DSPP structure exhibits much larger yet nonlinear sensitivity of both the critical pull-in displacement and the critical pull-in voltage to a small range of external acceleration, which has the potential of developing high-sensitivity accelerometers whenever the sensitivity nonlinearity is compensated. Moreover, the effects of pressure are characterized for both DSPP and SSPP devices, which affects the difference between the critical static and dynamic pull-in voltages. The SSPP structure is shown to have the critical pull-in voltage proportional to the logarithmic magnitude of the pressure, while that of the DSPP structure do not vary linearly with respect to the logarithmic magnitude of the pressure.

Dynamic Characteristics of MEMS Inertial Devices under High G-Force

Pull-In Dynamics of Two MEMS Parallel-Plate Structures for Acceleration Measurement

Finite Element Simulation on Packaging of Hinged High-G Micromachined Accelerometer

Damping characteristic analysis of MEMS inertial devices

Damping Characteristic Analysis Of Mems Inertial Devices - Art. No. 60400e

Characterization and In-Situ Test of Mechanical Properties of MEMS-Based Inertial Delay Slider Mechanism

IMPACT EXPERIMENT ANALYSIS OF MEMS ULTRA-HIGH G PIEZORESISTIVE SHOCK ACCELEROMETER

Design, fabrication and experiment of a MEMS piezoresistive high-g accelerometer

Structural Failure Analysis and Numerical Simulation of Microaccelerometers under Impulsive Loading

A Double-End Fixed Beam Structure of MEMS Piezoresistive High G Accelerometer

FINITE ELEMENT DYNAMICS ANALYSIS OF MICRO-SPRING IN MEMS INERTIA SWITCH

Design, Manufacture And Test Of Novel Mems Piezoresistive Accelerometer For High G Application

Analysis & Prevention on Pull-in Failure of Force Feedback Micro-Accelerometer after Heavy Impact

Resonant Frequency Analysis for Spring-Mass Structure in High-G MEMS Accelerometer

Investigation and experiment of high shock packaging technology for High-G MEMS accelerometer

Modeling and Simulation of A Silicon Integration Tri-Axial Piezoresistive MEMS Accelerometer Chip Used for High Impact Test

Study on Encapsulation and SMT Technology for MEMS High-g Acceleration Sensors

Study on the packaging technology for a high-G MEMS accelerometer

A Transfer Function Approach to Shock Duration Compensation for Laboratory Evaluation of Ultra-High-G Vacuum-Packaged MEMS Accelerometers

Investigation of nonlinear squeeze-film damping involving rarefied gas effect in micro-electro-mechanical-systems

Electromechanical Analysis of Microelectromechanical Structures and Dynamic Simulations of Laterally Vibratory Microgyroscope