Abstract:An experimental and numerical investigation into the tip leakage flow of a turbine rotor is carried out using a particle image velocimetry (PIV) system and the commercial software ANSYS CFX 14.0. The specimen used in this work is a typical GE-E-3 model with a new squealer tip design. The experimental data are used to create a turbulence model and numerical strategy. Through the validated turbulence model and numerical strategy, simulations are carried out to compare the characteristics of the tip leakage flow in three cases: (1) the blade is rotating, but the shroud is stationary, which is the real status of turbine rotor operation; (2) the blade is stationary, but the shroud moves, to simulate their relative movement; (3) the blade is stationary, and the shroud is also stationary, this is a simplified case, but has been widely used in the experiments on rotor tip leakage flow. Detailed analysis of the flow phenomena shows that the second case is a reasonable alternative approach to simulate the real state. However, the flow patterns in the third case exhibit some evident differences from the real status. These differences are caused by the inaccurate viscous force arising from the stationary blade and shroud. In this work, a modification method for the experiments conducted in the third case is firstly proposed, which is realized through adding an imaginary roughness at the shroud wall to be close to the real viscous effect, and to thereby reduce the deviation of the experiment from the real case. According to the results calculated by ANSYS CFX, the flow structure in the modification case is very close to the real status. Besides, this modification case is an easy and cheap way to simulate the real tip leakage flow.

Clearance-excitation force of shrouded turbine rotor accounting for pitching motion

A FLUID-STRUCTURE INTERACTION MODEL OF TURBINE ROTORS BASED ON A COMPREHENSIVE LEAKAGE FLOW MECHANISM

Influence of Clearance Parameters on the Rotor Dynamic Character of Hydraulic Turbine Shaft System

Characteristics Of Centrifugal Pump Rotor System Under Exciting Forces Generated By Shroud Leakage Flows

Numerical Investigations on the Blade Tip Clearance Excitation Forces in an Unshrouded Turbine

Comparative investigation of tip leakage flow and its effect on stage performance in shrouded and unshrouded turbines

Influence of Tip Clearance Distribution on Blade Vibration of Vaneless Radial Turbine

Tip Leakage Flow In Radial Inflow Rotor Of A Microturbine With Varying Blade-Shroud Clearance

Effect Of Relative Movement Between The Shroud And Blade On Tip Leakage Flow Characteristics

Rotordynamic Forces Generated by Discharge-to-suction Leakage Flows in Centrifugal Pumps

Numerical Investigation of Tip Clearance Flow in a Variable Geometry Turbine with Non-Uniform Partial Clearance

Dynamic Analysis of Rotor'S Radial Rub-Impact in Full Degrees of Freedom Accounting for Turborotor'S Non-Linear Clearance-Excitation Force

Study of the Phase Resonance Phenomenon in Francis Turbine

Study on Leakage Flow Characteristics of Radial Inflow Turbines at Rotor Tip Clearance

Clearance flow patterns and pressure distribution of a pump-turbine: Measurement and simulation of a rotating disk flow

Experimental And Numerical Investigations On The Aerodynamic Performance Of The Three-Stage Turbine With Consideration Of The Leakage Flow Effect

Influence factors of clearance leakage flowrate and clearance hydraulic axial force of pump-turbine

Models of the Rotor-Seal System for Hydraulic Turbine and Its Nonlinear Dynamics Analysis

A comprehensive CFD investigation of tip vortex trajectory in shrouded wind turbines using compressible RANS solver

Effects of Rotor Solidity and Leakage Flow on the Unsteady Flow in Axial Turbine

Investigation of Leakage Flow and Heat Transfer in A Gas Turbine Blade Tip with Emphasis on the Effect of Rotation