Abstract:Elucidating the hydrogen leakage and diffusion processes in confined environment is of vital importance for safety hazard assessment related to hydrogen leakage incidents. In the study, hydrogen leakage flowrates with 0.5 mm circular leakage port under 0.8–2.0 MPa were firstly measured. Subsequently, the 1-min hydrogen leakage and 3-min diffusion experiments were conducted in a 28.0 m 3 customized hydrogen leakage chamber with 26 hydrogen concentration sensors placed at the left-side wall, right-side wall, and roof wall. The real-time hydrogen concentration values at different spatial positions under no air ventilation conditions were monitored. Good consistency among the three repeated test results is observed. The averaged leakage flowrate is 74.68 NLPM at 1.0 MPa, and it reaches 144.67 NLPM at the leakage pressure of 2.0 MPa. Besides, the hydrogen leakage flowrate is found to follow a linear growth trend. The shortest time to reach 100 ppm is 14.6 s at a leakage flowrate of 61.86 NPLM, and it is reduced to 9.2 s at 144.67 NPLM. Meanwhile, the corresponding sensor label shifts from sensor B1 to sensor C2_L. With leakage flowrate increasing, the maximum detected hydrogen concentration keeps rising monotonously. The dynamic hydrogen concentration variations as well as contour map at side walls are demonstrated. The hydrogen concentrations at chamber middle positions are much lower than that of roof positions. It is further inferred that vortical motions exist at chamber corners and side walls. At the end of 240 s, the leaked hydrogen is observed to be uniformly distributed at the same horizontal level regardless of the leakage position. The study is ought to provide valuable test data for model validation in numerical simulations.

Experimental Study of Helium Leakage Parameters in Flexible Composite

Mechanics Analysis on Helium Leakage of Flexible Composites

Experimental Study on Damage-induced Helium Leakage in Flexible Composite

Theoretical and Experimental Investigation on Helium Leakage Characterization of Flexible Film-Fabric Laminated Composites

Diffusion measurements of isopentane, 1-hexene, cyclohexane in polyethylene particles by the intelligent gravimetric analyzer

Numerical Simulation on the Leakage and Diffusion of Hydrogen in Indoor Environment

Experimental Study of Pressure Drop-Flow Rate Characteristics of Heated Tight Porous Materials

Permeation of Compressed and Supercritical Fluids Through Porous Membranes

Quantitative analysis of hydrogen leakage and diffusion processes based on real-time concentration measurement at different spatial positions in a customized chamber

Helium leakage inspection method based on conservation of mass

Experimental Study on Telemetry of Hydrogen Leakage Based on Raman Spectroscopy

Impact of Pressure Difference on Leakage Rate from Rigid Positive Standard Leak:A Theoretical and Experimental Study

Helium Permeability Measurement of Sic Ceramic Composites for Advanced Reactor Application

Investigation of the Gas Permeation Properties Using the Volumetric Analysis Technique for Polyethylene Materials Enriched with Pure Gases under High Pressure: H2, He, N2, O2 and Ar

The Heat Conduction Model and Leakage Characterization of the Sealing Interface

Study of helium permeability for silica microspheres

A permeability membrane-type leak element based on PDMS

Simulation and theoretical studies on the influence of removable panel deformation on the seal characteristics of ceramic wafer seal

INVERSE ANALYSIS TO OBTAIN THE PRESSURE-DEPENDENT PERMEABILITY OF MICRO/NANO POROUS MATERIALS

Experimental and Simulation Research on Hydrogen Leakage of Double Ferrule Joints

A Robust Data Processing Method for Pulse-Decay Measurement of Tight Materials