Abstract:The effect of reduction partitioning in two-stage cold rolling on the microstructure, texture, and ridging resistance of ferritic stainless steel was investigated to obtain the optimal process to improve the surface quality of the sheets. In the present study, four different cold rolling processes were employed: conventional cold rolling without intermediate annealing (i.e., Route 1) and two-stage cold rolling with three different reduction partitionings (i.e., Routes 2, 3, and 4). In Route 1 final annealed sheets, significant surface ridging defects were observed due to relatively large grain sizes, pronounced oriented grain colonies and size grain colonies. The ridging resistance of the final annealed sheets in the two-stage cold rolling process improved compared to Route 1. In two-stage cold rolling, the optimal ridging resistance was obtained when the first-stage cold rolling employed a 50% reduction and the second-stage cold rolling employed an 80% reduction. The results show that the texture is mainly shifted from α-fiber orientation to γ-fiber orientation. Additionally, decreasing the {001} orientation volume fraction, improving the uniformity along the γ-fiber texture, increasing the γ-fiber intensity, and decreasing the average grain size of the final annealed sheets can improve the ridging resistance of the sheets. Moreover, eliminating orientation and size of grain colonies to achieve a uniform distribution is a key factor in improving the ridging resistance of the sheets. The appropriate reduction partitioning is a crucial factor in determining the ridging resistance of two-stage cold rolling final annealed sheets. Graphical

Δr of Drawability and the Choice of Cold Reduction

The Influence of Warm Rolling Reduction on Microstructure Evolution, Tensile Deformation Mechanism and Mechanical Properties of an Fe-30Mn-4Si-2Al TRIP/TWIP Steel

Effect of cold rolling reduction on microstructure, mechanical properties, and texture of deep drawing dual-phase (DP) steel

Effect of Cold Rolling Technology on Drawability of IF Steel

Microstructure, Texture, and Deep Drawability under Two Different Cold-Rolling Processes in Ferritic Stainless Steel

Prediction of Plastic Strain Ratio of Deep-Drawing IF Steel Sheets

Effect Of Drawing Pass On Softening Or Plasticizing Of Q235 Steel Bar During Electrochemical Cold Drawing

Effect of Secondary Cold Reduction Rates on Microstructure, Texture and Earing Behavior of Double Reduction Tinplate

Experimental Study of Hot Deep Drawing for Twin-Roll-cast AZ31 Alloy

Formation of recrystallization texture and its effect on deep drawability for high-purified ferritic stainless steel by two step cold rolling

Effect Of Cold Rolling Before Hydrogen Reduction On Reduction Behavior And Morphologies Of Oxide Scale On Hot-Rolled Low-Carbon Steel

Comparison of reduction ability between multi-stage cold drawing and rolling of stainless steel wire – Experimental and numerical investigations of damage

A study of longitudinal cracking and the forming technology for deep-drawn austenitic stainless-steel cups

Dynamic Recrystallization Behavior of Low‐Carbon Steel during the Flexible Rolling Process: Modeling and Characterization

Effects of Reduction Partitioning in Two-Stage Cold Rolling on the Surface Ridging Resistance of Ferritic Stainless Steel

Effect of cold process drawing parameters on the formability and microstructure of ribbed cladding tubes

Influences of rolling reduction on sheet metal formability

The Role of Cold Rolling Reduction on the Microstructure and Mechanical Properties of Ultra-Low Carbon Bainitic Steel

Mechanical Anisotropy and Deep Drawing Behaviors of Az31 Magnesium Alloy Sheets Produced by Unidirectional and Cross Rolling

Analysis of Friction Characteristics During the Thread Cold Rolling Process by Using a Novel Single-Tooth Rolling Friction Test

Drawing of the wire of low-carbon steel: plasticity resource, optimal reduction, structure, properties