Abstract:Effects of addition of cationic high molecular weight polymers (CP) as a primary flocculant or coagulant aid,,on the treatment efficiencies for raw water with low temperature (T10℃) and low turbidity (C010 NTU) were measured. The raw water was obtained from the Qujiang water treatment plant in Xi′an, China and investigated using a micro-flocculation depth-bed direct filtration process. Fractal mathematics and image analysis were used to analyze the effects of the following factors on treatment efficiencies: filter medium; raw water turbidity and temperature; chemical type, molecular weight and dosage of polymer; and mixing strength. The flocculation mechanism, floc morphologies and the fractal properties of floc structures were also compared after adding different flocculants. Five important results were obtained: ① It is not suitable to use Al2(SO4)3 (AS) or polyaluminium chloride (PAC) alone when T4℃, C04 NTU. Fine sand filter medium should be used if Al2(SO4)3 or PAC is added alone under the conditions 4℃T10℃, C010 NTU. For raw water with low temperature and turbidity, the flocs formed from inorganic coagulants are small, loose and fragile structures, with low efficient mass density and settling rate, but high fractal dimension. ②A coarse sand filter markedly improved CP flocculation efficiencies of raw water with low temperature and turbidity; but the mixing strength should be increased due to high viscosity of CP; ③It is appropriate to use low molecular weight polymers with weakly cationic properties or a lower dosage of CP with strong cationic properties if CP serves as a primary flocculant. When CP is used as a coagulant aid, the dosage of the primary coagulant can be greatly decreased, but it is better to use high molecular weight polymers with strong cationic properties or to increase the dosage of CP with weak cationic properties. ④The flocculation mechanisms of CP are charge neutralization, adsorption and bridging. Flocs formed from CP have have large network configurations, which lead to reduced sludge volumes and increased sludge settling rates as well as good dewatering behavior, but have a lower fractal dimension than inorganic flocs. ⑤ The treatment efficiencies of all tested flocculants are as follows: Al2(SO4)3 (or PAC) +CP CPPAC Al2(SO4)3 .

Performance and Mechanism of Polyferric-Quaternary Ammonium Salt Composite Flocculants in Treating High Organic Matter and High Alkalinity Surface Water.

Preparation and Application of Slag Compound Flocculant

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Physicochemical characterization and flocculation performance evaluation of PAC / PMAPTAC composite flocculant

Preparation, characterization and application of a composite bioflocculant

Flocculation performance evaluation and flocculation mechanism study of PAC/PMAPTAC composite flocculant in dyeing wastewater

Novel polyferric titanium silicate/chitosan composite flocculant for organic polymeric pollutant removal: optimization, performance and mechanism

An enhanced coagulation using ferric chloride and poly-ferric chloride coagulant assisted by polyamidine: Performance and mechanisms

Polymerization mechanism of polyferric aluminum phosphatic sulfate (PFAPS) and its flocculation effect on simulated dye wastewater

Study on the pretreatment of printing & dyeing wastewater with composite polyaluminum ferric flocculants

Chorea–acanthocytosis presenting with schizophrenia symptoms as first symptoms

Enhanced primary treatment of low-concentration municipal wastewater by means of bio-flocculant Pullulan

[Removal of Turbidity and Effect of Humic Acid in Flocculation by Polyferric Chloride].

Enhanced Coagulation-Flocculation Performance of Iron-Based Coagulants: Effects of PO4(3-) and SiO3(2-) Modifiers

Flocculation Efficiencies and Morphological Properties of Cationic Polymers in the Treatment of Low Temperature and Low Turbidity Raw Water

Insight into Control Mechanism of Polymeric Ferric Titanium Composite Coagulant on Membrane Fouling: Role of Natural Organic Matters

Enhanced performance of a novel flocculant containing rich fluorine groups in refractory dyeing wastewater treatment: Removal mechanisms

Flocculation Performance of PCFA Composite Coagulant for Removing Nanoparticles

PROBING INTO THE MECHANISM OF COMPOSITE POLYALUMINUM SILICATE FLOCCULANTS WITH ION-EXCHANGE TECHNIQUE

Study on the Performance of a Novel Inorganic Polymeric Flocculant

Preparation and Applications of Inorganic Polymer Flocculant Poly Aluminum Ferric Sulfate