Abstract:Effects of addition of cationic high molecular weight polymers (CP) as a primary flocculant or coagulant aid,,on the treatment efficiencies for raw water with low temperature (T10℃) and low turbidity (C010 NTU) were measured. The raw water was obtained from the Qujiang water treatment plant in Xi′an, China and investigated using a micro-flocculation depth-bed direct filtration process. Fractal mathematics and image analysis were used to analyze the effects of the following factors on treatment efficiencies: filter medium; raw water turbidity and temperature; chemical type, molecular weight and dosage of polymer; and mixing strength. The flocculation mechanism, floc morphologies and the fractal properties of floc structures were also compared after adding different flocculants. Five important results were obtained: ① It is not suitable to use Al2(SO4)3 (AS) or polyaluminium chloride (PAC) alone when T4℃, C04 NTU. Fine sand filter medium should be used if Al2(SO4)3 or PAC is added alone under the conditions 4℃T10℃, C010 NTU. For raw water with low temperature and turbidity, the flocs formed from inorganic coagulants are small, loose and fragile structures, with low efficient mass density and settling rate, but high fractal dimension. ②A coarse sand filter markedly improved CP flocculation efficiencies of raw water with low temperature and turbidity; but the mixing strength should be increased due to high viscosity of CP; ③It is appropriate to use low molecular weight polymers with weakly cationic properties or a lower dosage of CP with strong cationic properties if CP serves as a primary flocculant. When CP is used as a coagulant aid, the dosage of the primary coagulant can be greatly decreased, but it is better to use high molecular weight polymers with strong cationic properties or to increase the dosage of CP with weak cationic properties. ④The flocculation mechanisms of CP are charge neutralization, adsorption and bridging. Flocs formed from CP have have large network configurations, which lead to reduced sludge volumes and increased sludge settling rates as well as good dewatering behavior, but have a lower fractal dimension than inorganic flocs. ⑤ The treatment efficiencies of all tested flocculants are as follows: Al2(SO4)3 (or PAC) +CP CPPAC Al2(SO4)3 .

Enhanced primary treatment of low-concentration municipal wastewater by means of bio-flocculant Pullulan

Enhanced Flocculation As the Pretreatment for Biopollutant Laboratory Wastewater

Study on Enhanced Dewatering of Surplus Sludge from Municipal Wastewater Treatment Plant by Electroflocculation Process with Electrode Plates

Optimization and Characterization of Polysaccharide-Based Bioflocculant Produced by Paenibacillus Elgii B69 and Its Application in Wastewater Treatment

Influence of composite flocculant FeCl3-APAM on vacuum drainage of river-dredged sludge

Study on the pretreatment of printing & dyeing wastewater with composite polyaluminum ferric flocculants

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Evaluation of a Novel Chitosan-Based Flocculant with High Flocculation Performance, Low Toxicity and Good Floc Properties

Synergistic Enhancement of Pollutant Removal from High-Salt Wastewater Using Coagulation-Flotation Combined Process

Coagulation efficiency and removal mechanism for composite coagulant polyaluminium chloride/polydimethyldiallylammonium chloride in treating lightly micro-polluted raw water of Yangtze River in autumn

An Experiment on Using Modified Starch Flocculant and PAC Complex to the Wastewater Treatment

Treatment of polluted river water using potential bioflocculant produced by Klebsiella pneumonia UKD24

Synthesis of an Eco-friendly Bamboo Cellulose-grafted-ployacrylamide Flocculant and Its Flocculation Performance on Papermaking Wastewater

Sludge conditioning using the composite of a bioflocculant and PAC for enhancement in dewaterability

Municipal Wastewater Treatment by Enhanced Coagulation with A New Coagulant Containing Humic Acid

An enhanced coagulation using ferric chloride and poly-ferric chloride coagulant assisted by polyamidine: Performance and mechanisms

Flocculation performance evaluation and flocculation mechanism study of PAC/PMAPTAC composite flocculant in dyeing wastewater

Flocculation Efficiencies and Morphological Properties of Cationic Polymers in the Treatment of Low Temperature and Low Turbidity Raw Water

APPLICATION OF COMPOSITE FLOCCULANT OF CHITOSAN IN TREATING CITY'S SEWAGE WATER

To treat wastewater with wastes: a highly efficient flocculant from fly ash and rice straw

Optimization of the Coagulation-Flocculation Process for Pulp Mill Wastewater Treatment Using a Combination of Uniform Design and Response Surface Methodology