Abstract:The microstructure and electrical–optical properties of Al-doped ZnO (AZO) films have been studied as a function of H2 flux in the magnetron sputtering process at 150 °C and postannealing temperature in vacuum. As H2 flux increases in the sputtering gas, the AZO films deposited have a (002) preferred orientation rather than the mixed (100) and (002) orientations, the grain size shows a tendency to first increase then decrease, and (002) diffraction peak position is inclined to shift to higher angles first then to lower angles. The resistivity of the films first decreases then increases with H2 flux, and the lowest resistivity of 4.02 × 10−4 Ω cm is obtained at a H2 flux of 10 sccm. The average transmittance in the visible region shows little dependence on H2 flux. As a whole, the AZO films with higher values of figure of merit are obtained when the H2 flux is in the range of 6–12 sccm. The AZO films deposited in Ar and Ar + H2 exhibit different annealing behaviors. For the AZO film deposited in Ar, the grain size gradually increases, the stresses are relaxed, the resistivity first decreases then increases, and the average transmittance in the visible region is unchanged initially then somewhat decreased as annealing temperature is increased. The optimum annealing temperature for improving properties of AZO films deposited in Ar is 300 °C. For the AZO films deposited in Ar + H2, annealing does not significantly change the microstructure but increases the resistivity of the films; the average transmittance in the visible region remains unchanged initially but greatly reduced with further increase in annealing temperature. The carrier transport in the as-deposited and annealed films appears to be controlled by a mechanism of grain boundary scattering, and the value of Eg increases with the increase in carrier concentration due to Burstein–Moss effect.

Effects of γ Ray Irradiation and Atomic Oxygen Treatment on ZnO:Al Films

Influence of O_2/Ar Flow Ratio on Microstructures and Photoluminescence of ZnO Films

Microstructure and Optical Properties of ZnO Films Deposited by Radio-frequency Reactive Magnetron Sputtering

Atomic oxygen treatment effects on magnetron sputtered Zr–Ti binary films

Deposition and Characterization of AZO Thin Films on Flexible Glass Substrates Using DC Magnetron Sputtering Technique

Effect of Solution Concentrations on Crystal Structure, Surface Topographies and Photoluminescence Properties of ZnO Thin Films

Effect of Rapid Thermal Annealing Ambient on Photoluminescence of Zno Films

Microstructure and Electrical Properties of Al-doped ZnO Thin Films

Effects of Hydrogen Flux on Aluminum Doped Zinc Thin Films by Pulsed Magnetron Sputtering

Air Annealing Effect on Oxygen Vacancy Defects in Al-doped ZnO Films Grown by High-Speed Atmospheric Atomic Layer Deposition

Al-doped ZnO (ZAO) Films Prepared by Middle-frequency Alternative Magnetron Sputtering

Effect of Argon Annealing Treatment on Photoelectric Properties of GZO Films Deposited by Atomic Layer Deposition

Effect of technologic parameters on the performances of ZAO thin films deposited by magnetron sputtering

Infrared Properties And Mechanism Of Al-Doped Zno Thin Films

Characteristics of Al-doped ZnO Thin Films Prepared in Ar + H2 Atmosphere and Their Vacuum Annealing Behavior

Annealing effect on mechanical properties of RF magnetron sputtering ZnO thin film

Effect of rapid thermal annealing on the properties of zinc tin oxide films prepared by plasma-enhanced atomic layer deposition

In Situ and Ex Situ Investigation on the Annealing Performance of the Zno Film Grown by Ion Beam Deposition

MICROSTRUCTURE AND PROPERTIES OF ANNEALED ZnO THIN FILMS DEPOSITED BY MAGNETRON SPUTTERING

Study on Aluminum Concentration on Optical and Electrical Properties of AZO Thin Films Fabricated by Ultrasonic Spray Pyrolysis

Effect of Post-Thermal Annealing on Properties of Zno Thin Film Grown on C-Al(2)O(3)By Metal-Organic Chemical Vapor Deposition