Abstract:Environmental sensing units such as gas sensors, humidity sensors, pressure sensors, PM 2.5 sensors, or temperature sensors are widely used in our daily lives. In this study, CMOS-MEMS technology is exploited to fabricate and monolithically integrate the photo-sensors, temperature sensor, and mechanical structures for an optical gas sensing chip. An LED is bonded (heterogeneous integration) on the CMOS-MEMS chip as an excitation light source, and fluorescence quenching technology is employed for the presented optical gas sensor. Finally, the light emitted from the LED is reflected and redirected onto the CMOS-MEMS chip by using an encapsulated optical reflector to increase the sensitivity and reduce the power consumption for the presented sensor. In applications, the sensing materials are, respectively, mixed with C30H24Cl2N6Ru center dot 6H(2)O and C16H7Na3O10S3 for O-2 and CO2 detection. Moreover, the Si-based (by micromachining) and polymer-based (by 3D printing) optical reflectors are used to encapsulate the sensing chip to demonstrate the presented concept. Measurements show that the LED driving currents for gas sensors with reflectors are significantly reduced. Measurements also indicate that the sensitivities of gas sensors for sensing chips without optical reflectors are, respectively, 0.023 mu A/% (O-2/N-2) and 0.12 mu A/% (CO2/N-2); for sensing chips with hemispherical shell optical reflectors are, respectively, 0.12 mu A/% (O-2/N-2) and 0.19 mu A/% (CO2/N-2); and for sensing chips with flat plate optical reflectors are, respectively, 0.24 mu A/% (O-2/N-2) and 0.32 mu A/% (CO2/N-2). The sensitivity of the temperature sensor is 0.07%/degrees C.

Design and optimization of an integrated MEMS gas chamber with high transmissivity

Designing an optical gas chamber with stepped structure for non-dispersive infrared methane gas sensor

The design of a new integrated gas sensor array based on FEA

Ultrasensitive Transmissive Infrared Spectroscopy Via Loss Engineering of Metallic Nanoantennas for Compact Devices

Development of a Compact NDIR CO2 Gas Sensor for a Portable Gas Analyzer

Non-Silicon MEMS Calorimetric Gas Flow Sensor

Development of High-Precision NO2 Gas Sensor Based on Non-Dispersive Infrared Technology

An ultracompact refractive index gas-sensor based on photonic crystal microcavity

Gas Detection Microsystem With MEMS Gas Sensor and Integrated Circuit

Miniaturised Infrared Spectrophotometer for Low Power Consumption Multi-Gas Sensing

Design and Implementation of Multi-Layer Opened-IDAs Electrodes for the Response Enhancement of CMOS-MEMS Gas Sensors at Room Temperature

Design And Implementation Of Gas Sensor Array Based On Fluorescence Quenching Detection Using Cmos-Mems Process

A Fully Integrated Gas Detection System With Programmable Heating Voltage and Digital Output Rate for Gas Sensor Array

Design and Fabrication of MOS Type Gas Sensor with Vertically Integrated Heater Using CMOS-MEMS Technology

MEMS-based Sensing Technology for the Gas Chromatograph Analysis

Integration and Encapsulation of Light-Emitting Diode and CMOS-MEMS Chips for Fluorescence Quenching Gas Sensor

Direct Bonding SOI Wafer Based MEMS Cantilever Resonator for Trace Gas Sensor Applicaiton

Design of high concentration oxygen sensor based on MEMS chip

Micro/Nano Gas Sensors: A New Strategy Towards In-Situ Wafer-Level Fabrication of High-Performance Gas Sensing Chips

Non-dispersive infrared multi-gas sensing via nanoantenna integrated narrowband detectors