Abstract:Nanocrystalline barium titanate (BaTiO3, BT) was synthesized hydrothermally at 220°C by reacting barium hydroxide with titanium dioxide. The resulting BT nanopowders were characterized by X‐ray diffraction (XRD), selected area electron diffraction (SAED), Raman spectrum, scanning electron microscopy (SEM), and high‐resolution transmission electron microscopy (HR‐TEM). The BT nanopowders have a cubic phase as revealed by the XRD and SAED results, whereas the Raman spectrum indicates that tetragonal phase BT exists in the produced nanopowders but is not the dominant phase because of the weak characteristic peak of the tetragonal structure at 305 cm−1. In the SEM and TEM images, many coarse‐faceted cubic nanoparticles and a small amount of spherical particles are observed, indicating a developed bimodal size distribution of the BT powders. The variations of electron diffraction contrast across these particles in the TEM images indicate the presence of high strain in the BT nanoparticles, which is probably caused by the lattice defects like OH− ions and their compensation by cation vacancies. The HR‐TEM image of a BT nanoparticle with a size of 24 nm and a spherical morphology demonstrates a uniform and perfect crystal structure. The surrounding edges of the particle are very smooth and no surface steps are observed. However, a terrace–ledge–kink (TLK) surface structure was frequently observed at the edges of the BT nanoparticles with rough surface morphology, and in most cases the terrace and ledge lie on the {100} planes. The observed TLK surface structure can be well interpreted by the theory of periodic bond chains. Small nucleated and triangular BT islands with three to four atomic layer thickness, and their outside surfaces faceted as (100) and (010) planes, are also observed in these particles. The rarely seen {110} surface in the BT nanoparticles was found to be reconstructed so that the surface was composed of corners bound by {100} minifaces like the triangular small islands. Microstructural defects such as antiphase boundaries were also observed near the edge of a BT nanoparticle, which were formed by the intersection of two crystalline parts with displacement deviation from each other by , as revealed by the HR‐TEM images.

Hemocompatibility and Antioxidant Properties of Nano-Sized Barium Titanate in Cubic and Tetragonal System

Influence of Annealing Temperature on Microstructure and Phase Transformations of Oxide System Bi2O3/TiO2 Formed in Aqueous Solutions

Preparation of A Monodispersed Suspension of Barium Titanate Nanoparticles and Electrophoretic Deposition of Thin Films

Study on the Hydrothermal Synthesis of Barium Titanate Nano-Powders and Calcination Parameters

Preparation and characterizations of tetragonal barium titanate powders by hydrothermal method

LOW-TEMPERATURE SYNTHESIS OF BARIUM TITANITE IN AQUEOUS SOLUTION

Preparation,Structure and Characterization of Nano-Grained Barium Titanate Ceramics

Tetragonal Nanocrystalline Barium Titanate Powder: Preparation, Characterization, and Dielectric Properties

In-situ thermal phase transition and structural investigation of ferroelectric tetragonal barium titanate nanopowders with pseudo-cubic phase

Study of Structural and Photoluminescent Properties in Barium Titanate Nanocrystals Synthesized by Hydrothermal Process

Atomic‐Scale Characterization of Barium Titanate Powders Formed by the Hydrothermal Process

Preparation for BaTiO3 Nano-crystalline Powder and Study on the Sintering Characteristics of Ceramic

Effects of Calcination Temperature on the Synthesis of One-Pot Sol-Gelled Barium Titanate Powder and Its Performance as an Endodontic Radiopacifier

Effects of Chemical Modification on the Structural and Electrical Properties of (ba0.90ca0.10)0.90(na0.5bi0.5)0.10tio3 Ceramics

Investigation of the photocatalytic activity of ceramic nanocomposite material based on BATIO 3 with iron oxide

Morphology and atomic-scale surface structure of barium titanate nanocrystals formed at hydrothermal conditions

Microstructural Characterization of BaTiO3 Ceramic Nanoparticles Synthesized by the Hydrothermal Technique

Investigation of heat treatment condition, ethylene glycol and deionized water effects on the phase structure of Ba0.6Sr0.4TiO3 nanoparticles produced by the sol-gel method

Hydrothermal Synthesis of Tetragonal Barium Titanate Nanopowders under Moderate Conditions

Structure and Properties of Barium Strontium Titanate Nanoparticles Synthesized by A Hydrothermal Method

Synthesis and characterization of nanocrystalline barium strontium titanate powder by a modified sol-gel processing