Abstract:TiO2 nanoparticles acquire complete crystalline anatase phase on thermal treatment of as-prepared anatase TiO2 at 450°C. Anatase-rutile mixed phase and rutile phase are achieved by annealing anatase TiO2 at 700°C and 950°C respectively. The anatase-rutile mixed phase TiO2 has 87.8% rutile phase. This signifies that the percentage of rutile fraction in mixed phase can be tailored by changing the annealing temperature. As-prepared anatase TiO2 with a crystallite size of 5 nm has a positive strain (η) of 0.0345, which is due to the presence of oxygen defects on the surface and on the grain boundary. Removal of defects releases the strain and relaxes the lattice to its normal state, and thus, a negative strain η of (−) 0.0006 is observed in complete rutile phase. The interface between nearest anatase crystallites and between anatase and rutile crystallites contains oxygen vacancies that act as nucleation site for the growth of rutile nuclei. These oxygen defects are responsible for the broadening of the Raman Eg peak of anatase and for the shortening of the phonon lifetime in a 5-nm-sized anatase nanocrystallite. Removal of defects decreases the Raman peak width and increases the phonon lifetime in a larger rutile crystallite. The long lifetime of phonon in a larger rutile crystallite is due to temperature-dependent anharmonic phonon coupling.

Effects of annealing temperature on structural phase transition and microstructure evolution of hydrothermally synthesized barium titanate nanoparticles

Influence of Annealing Temperature on Microstructure and Phase Transformations of Oxide System Bi2O3/TiO2 Formed in Aqueous Solutions

Effects of Annealing Temperature on the Structures, Ferroelectric and Magnetic Properties of Aurivillius Bi5ti3feo15 Polycrystalline Films

Barium titanate derived from mechanochemically activated powders

Effect of annealing temperature on phase transition and optical property of titanate nanotubes prepared by ion exchange approach

In-situ thermal phase transition and structural investigation of ferroelectric tetragonal barium titanate nanopowders with pseudo-cubic phase

Effect of Calcination Temperature on the Microstructures of Barium Titanate Hafnate Nanopowders Prepared by the Sol-Gel Process

Effect of Annealing on the Structure and Diamagnetic Transition Width of High-Quality Crystal Bi2sr2cacu2oy Studied by X-Ray-Diffraction and Ac Susceptibility Measurements

Preparation and characterizations of tetragonal barium titanate powders by hydrothermal method

Study of Structural and Photoluminescent Properties in Barium Titanate Nanocrystals Synthesized by Hydrothermal Process

Microstructures and photoluminescence of barium titanate nanocrystals synthesized by the hydrothermal process

Effect of Annealing Temperature on Properties of Barium Zirconium Titanate Thin Films Deposited by Sol-Gel Method

The effect of annealing temperature on the structure and dielectric properties of (Ba/sub 0.6/Sr/sub 0.4/)TiO/sub 3/ thin films

Epitaxially Induced High Temperature (>900K) Cubic-Tetragonal Structural Phase Transition in BaTiO3 Thin Films

Study on the Hydrothermal Synthesis of Barium Titanate Nano-Powders and Calcination Parameters

Local structure modification and phase transformation of TiO2 nanoparticles initiated by oxygen defects, grain size, and annealing temperature

Effect of annealing temperature on morphology, structure and photocatalytic behavior of nanotubed H2Ti2O4(OH)2

Effects of Annealing on Microstructure and Optical Properties of TiO 2 Sculptured Thin Films

The effect of post-annealing on barium strontium titanate films deposited by radio frequency magnetron sputtering

Effect of Oxygen Partial Pressure and Anneal Temperature on Batio3 Thin Film Crystal Structure

Effect of Annealing on Ferroelectric Properties of Nanometre BaTiO 3 Ceramics Prepared by High Pressure Sintering Method