Abstract:Vibration behaviors of bogie hunting motion contain key information that dominates the dynamic performance of rail vehicles, in which the eigenvalue of each mode reflects the damping ratio and the natural frequency. This paper focuses on the root loci curves of bogie hunting motion, starting from a rigid bogie, then to a bogie with flexible primary suspension. With regard to the rigid bogie, analytical formulas for the eigenvalues, the critical speed as well as the corresponding hunting frequency are derived and verified. While for the flexible bogie, the root loci curves are calculated numerically. The study shows that both free rigid bogie and free wheelset are dynamically unstable at any speed. The critical speed increases with diminished wheel-rail conicity, track gauge, and wheelset and bogie inertia, and with increased wheelbase and wheel radius. The dominating factors such as the stiffness of the primary suspension and the wheel-rail conicity should be optimized for a practical design. The influences of the damping coefficients and the variations of creep coefficients are negligible. The motor suspension affects the root loci curves and the critical speed significantly. Both inappropriate motor suspension design and rigidly suspended motor reduce the critical speed. The increase of critical speed by a motor suspension can only be achieved when the lower natural frequency of the motorbogie frame-wheelsets system coincides with or is close to the hunting frequency. Special care should be taken for the design of motor suspension, the first is to avoid the decreased damping ratio in a certain speed range below the critical speed and the second is that the variations of parameters should not induce the rapid reduction of the critical speed. The main feature of the present study is that the root loci curves, which are derived as analytical formulas or calculated numerically, are used to study the vibrational behaviors of bogie hunting motion. Both the influencing laws of the dominating parameters and the principles regarding the motor suspension are significant for the stability design of modern railway vehicles which may use innovative structures/materials as well as modern control and monitoring technologies.

Carbody hunting behaviour of high speed vehicles in low effective conicity of wheel-rail contact

Carbody abnormal lateral vibration failure of high–speed train induced by the coupling factor of the wheel re–profiling method and excessive rail wear

Investigating the effect of rail profile deviation on hunting instability of high-speed railway vehicle under multi-parameter coupling

Experimental and numerical research on the bogie hunting of a high-speed train caused by the empty stroke of yaw damper

Numerical Investigation into the Critical Speed and Frequency of the Hunting Motion in Railway Vehicle System

The effect of yaw damper performance degradation on carbody hunting of high-speed trains

Carbody swaying suppression for a high-speed rail vehicle by utilising active lateral suspension control

Coupling effect of track irregularity and wheel–rail contact conicity on carbody swaying of a metro vehicle: an experimental investigation

Mechanism analysis of low-frequency swaying motion of high-speed trains induced by aerodynamic loads

Bifurcation and stability analysis of a high-speed rail vehicle with active yaw dampers

Mechanism of high-speed train carbody shaking due to degradation of wheel-rail contact geometry

Linear stability analysis of a high-speed rail vehicle concerning suspension parameters variation and active control

Study on dynamic performance of high-speed railway vehicle using roller rig and numerical simulation

Vibration characteristics of bogie hunting motion based on root loci curves

Effect of car-body lower-center rolling on aerodynamic performance of a high-speed train

Study of Resonance between Bogie Hunting and Carbody Mode via Field Measurements and Dynamic Simulation

Hunting stability and dynamic stress analysis of a high-speed bogie using elastic-suspended motors as dynamic vibration absorber

Effects of the Dynamic Wheel–rail Interaction on the Ground Vibration Generated by a Moving Train

Experimental and numerical study on bogie hunting motion of metro vehicles induced by wheel concave wear

Ground Vibration Caused by Axle Load and Dynamic Wheel-Rail Force of a Moving Train

Bio‐inspired structure constraints following control for enhancing hunting stability of high‐speed trains