Abstract:With the rapid development of high-speed railway (HSR) in China, the problem of environmental vibration induced by HSR train has attracted critical concern. In this paper, a combination vibration reduction (CVR) strategy of hollow-closed-wall in-filled trench (HIT) and elastic bearing (EB) is proposed to decrease environmental vibration induced by HSR train, in which the depth of HIT could be well controlled to benefit the practical construction and economic cost. Based on the multi-body dynamics and finite element theory, HSR environmental vibration system is established and then divided into two sub-models including the 'train-track-bridge' vibration source sub-model and the 'pile-soil' vibration propagation sub-model. The two sub-models are connected via the force balance condition of the pier bottom. The verification of numerical models is conducted by comparing with the empirical formula and the ground data in the references. Then the attenuation law of environmental vibration is analyzed, and the vertical component is shown to be dominant in the HSR environmental vibration. On this basis, numerical simulations are performed to analyze the environmental vibration reduction under three strategies, namely the HIT, EB, and CVR. The results show that the HIT presents a distinct vibration reduction effect in the frequency range above 4 Hz and the vibration reduction becomes more obvious as the HIT's depth increases. However, the depth should be larger than 8 m to satisfy the code requirement; the EB presents an obvious reduction in the frequency range above 8 Hz; the CVR strategy not only further decrease the environmental vibration, but also effectively reduce the HIT's depth. By numerical analysis, the combination strategy of 6 m deep HIT and 2200 kN/mm vertical stiffness EB is recommended in the HSR environmental vibration reduction, which could also satisfy the limit of Chinese railway code.

Bio‐inspired structure constraints following control for enhancing hunting stability of high‐speed trains

Adaptive robust constraint-following control method for improving carbody hunting stability of high-speed trains

Robust Constraint-Following Control for Bio-Inspired Structure Oriented Active Suspension System of High-Speed Trains

Adaptive control of a vehicle-seat-human coupled model using quasi-zero-stiffness vibration isolator as seat suspension

Carbody hunting behaviour of high speed vehicles in low effective conicity of wheel-rail contact

An Active Repetitive Learning Control Method for Lateral Suspension Systems of High-Speed Trains

A new semi-active control strategy on lateral suspension systems of high-speed trains and its application in HIL test rig

Carbody swaying suppression for a high-speed rail vehicle by utilising active lateral suspension control

Linear stability analysis of a high-speed rail vehicle concerning suspension parameters variation and active control

Bifurcation and stability analysis of a high-speed rail vehicle with active yaw dampers

Constraint-following control design for active suspension systems

Hunting stability analysis of high-speed train bogie under the frame lateral vibration active control

A new hybrid control strategy for improving ride comfort on lateral suspension system of railway vehicle

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Speed tracking control of high-speed train based on adaptive control and linear active disturbance rejection control

Analysis on new semi-active control strategies to reduce lateral vibrations of high-speed trains by simulation and hardware-in-the-loop testing

Semi-active control of primary suspensions to improve ride quality in a high-speed railway vehicle

The effect of yaw damper performance degradation on carbody hunting of high-speed trains

Adaptive Nonsingular Terminal Sliding Mode Tracking Control for High-speed Trains With Input Constraints and Parametric Uncertainties

Disturbance observer-based sliding mode control of active vertical suspension for high-speed rail vehicles

Research on Coordinated Control of Vehicle Inertial Suspension Using the Dynamic Surface Control Theory