Abstract:With the rapid development of high-speed railway (HSR) in China, the problem of environmental vibration induced by HSR train has attracted critical concern. In this paper, a combination vibration reduction (CVR) strategy of hollow-closed-wall in-filled trench (HIT) and elastic bearing (EB) is proposed to decrease environmental vibration induced by HSR train, in which the depth of HIT could be well controlled to benefit the practical construction and economic cost. Based on the multi-body dynamics and finite element theory, HSR environmental vibration system is established and then divided into two sub-models including the 'train-track-bridge' vibration source sub-model and the 'pile-soil' vibration propagation sub-model. The two sub-models are connected via the force balance condition of the pier bottom. The verification of numerical models is conducted by comparing with the empirical formula and the ground data in the references. Then the attenuation law of environmental vibration is analyzed, and the vertical component is shown to be dominant in the HSR environmental vibration. On this basis, numerical simulations are performed to analyze the environmental vibration reduction under three strategies, namely the HIT, EB, and CVR. The results show that the HIT presents a distinct vibration reduction effect in the frequency range above 4 Hz and the vibration reduction becomes more obvious as the HIT's depth increases. However, the depth should be larger than 8 m to satisfy the code requirement; the EB presents an obvious reduction in the frequency range above 8 Hz; the CVR strategy not only further decrease the environmental vibration, but also effectively reduce the HIT's depth. By numerical analysis, the combination strategy of 6 m deep HIT and 2200 kN/mm vertical stiffness EB is recommended in the HSR environmental vibration reduction, which could also satisfy the limit of Chinese railway code.

The effect of yaw damper performance degradation on carbody hunting of high-speed trains

Modelling and simulation of nonlinear dynamic characteristics of yaw dampers subjected to variable temperature operation condition of high-speed trains

Improving the stability of high-speed trains using an innovative passive yaw damper

Experimental and numerical research on the bogie hunting of a high-speed train caused by the empty stroke of yaw damper

Effect of an inter-vehicle damper on the dynamics of a high-speed train

Numerical and experimental study on adaptive stiffness yaw damper for suppressing abnormal vibration of high-speed trains

Carbody hunting behaviour of high speed vehicles in low effective conicity of wheel-rail contact

Bifurcation and stability analysis of a high-speed rail vehicle with active yaw dampers

Effect of car-body lower-center rolling on aerodynamic performance of a high-speed train

Optimisation of an inter-vehicle damper for a high-speed train

Linear stability analysis of a high-speed rail vehicle concerning suspension parameters variation and active control

Effect of the Anti-Yaw Damper on Carbody Vertical Vibration and Ride Comfort of Railway Vehicle

Analysis and control of high-speed train lateral vibration on the basis of a conditionally triggered model predictive control strategy

A new semi-active control strategy on lateral suspension systems of high-speed trains and its application in HIL test rig

Numerical Investigation into the Critical Speed and Frequency of the Hunting Motion in Railway Vehicle System

A hybrid damping control strategy for high-speed trains running on existing tracks

Mechanism analysis of low-frequency swaying motion of high-speed trains induced by aerodynamic loads

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Adaptive robust constraint-following control method for improving carbody hunting stability of high-speed trains

Investigating the effect of rail profile deviation on hunting instability of high-speed railway vehicle under multi-parameter coupling

Effects of the Dynamic Wheel–rail Interaction on the Ground Vibration Generated by a Moving Train