Abstract:Thin-layer Al/MgF2 coatings are currently used for extraterrestrial far-UV astronomy as the primary and secondary mirrors of telescopes (such as “Spektr-UF”). Successful Hubble far-UV measurements have been performed thanks to MgF2 on Al mirror coatings. Damage of such thin-layer coatings has been previously studied under exposure to high-energy electrons/protons fluxes and in low Earth orbit environments. Meanwhile, there is an interest to test the stability of such mirrors under the impact of extreme radiation fluxes from pulsed plasma thrusters as a simulation of emergency onboard situations and other applications. In the present studies, the high current and compressed plasma jets were generated by a laboratory plasma thruster prototype and operated as effective emitters of high brightness (with an integral overall wavelength radiation flux of >1 MW/cm2) and broadband radiation. The spectrum rearrangement and hard-photon cut-off at energy above Ec were implemented by selection of a background gas in the discharge chamber. The discharges in air (Ec ≈ 6 eV), argon (Ec ≈ 15 eV) and neon (Ec ≈ 21 eV) were studied. X-ray diffraction and reflectometry, electron and atomic force microscopy, and IR and visible spectroscopy were used for coating characterization and estimation of degradation degree. In the case of the discharges in air with photon energies of E < 6 eV, only individual nanocracks were found and property changes were negligible. In the case of inert gases, the energy fraction was ≈50% in the VUV range. As found for inert background gases, an emission of such hard photons with energies higher than the MgF2 band gap energy of ≈10.8 eV caused a drastic light-induced ablation and degradation of the irradiated coatings. The upward trend of degradation with an increasing of the maximum photon energies was detected. The obtained data on the surface destruction are useful for the design of methods for coating stability tests and an understanding of the consequences of emergencies onboard space research stations.

Study on the UV FEL single-shot damage threshold of an Au thin film

Researches on Laser Damage Resistance of Optical Films

Traceless Mitigation of Laser Damage Precursors on a Fused Silica Surface by Combining Reactive Ion Beam Etching with Dynamic Chemical Etching

Damage threshold measurements on EUV optics using focused radiation from a table-top laser produced plasma source

Ultrafast Laser Material Damage Simulation—A New Look at an Old Problem

Damage threshold evaluation of thin metallic films exposed to femtosecond laser pulses: The role of material thickness

Study of Laser-Irradiated Thin Films

An Atomic-Level Study of Material Ablation and Spallation in Ultrafast Laser Processing of Gold Films

Self-focusing and stimulated Brillouin scattering effect of low-temporal coherence light and corresponding damage characteristics in fused silica

Effect of Different Etching Processes on Surface Defects of Quartz Crystals

Optical damage threshold of Au nanowires in strong femtosecond laser fields

Laser-induced damage thresholds of bulk and coating optical materials at 1030 nm, 500 fs

Defect Analysis of UV High-Reflective Coatings Used in the High Power Laser System

Simulation Study On The Influence Of Subsurface Deficiency On Fused Silica Laser Damage Threshold

Study on UV-laser fatigue damage of sol-gel antireflective coating using XPS and slow positron beam Doppler broadening spectrum

Surface Degradation of Thin-Layer Al/MgF2 Mirrors under Exposure to Powerful VUV Radiation

Dynamics of Femtosecond Laser Pulse Induced Damage in Multilayers

Numerical simulation study of ultraviolet nanosecond laser ablation of Cu-Al2O3 dispersion strengthened alloys

Research on the mitigation of redeposition defects on the fused silica surface during wet etching process

Laser-induced damage growth of large-aperture fused silica optics under high-fluence 351 nm laser irradiation

Various damage mechanisms in carbon and silicon materials under femtosecond x-ray irradiation