Abstract:The structure, morphology, and mechanical properties of two compression-molded grades of ultrahigh-molecular-weight polyethylene (UHMWPE) and, for comparison, one conventional linear polyethylene (HDPE) were studied. Compression molding resulted in some preferred orientation of lamellae in the compression direction in UHMWPE samples, while no preferred orientation in HDPE. The mean crystal thickness estimated from the size distribution agrees better with those obtained from small-angle X-ray scattering (SAXS) and mechanical yield data than the thickness determined from the melting peak temperature. Microscopic examination of microtomed and etched UHMWPE samples showed that the lamellae are in the form of platelets with the width and length in the range of 300-700 nm. The lamellae radiate from primary nuclei forming small embryonal spherulites; their radial growth ends at 0.3-0.7 μm from the center. There is no evidence of branching and secondary nucleation from those primary lamellae. Because the lamellae are radially ordered, there is no parallel stacking of lamellae. Samples were subjected to deformation by plane-strain compression at a constant true strain rate. In axial UHMWPE samples, where lamellae were preferentially oriented along the loading direction, the second yield was clearly observed. The second yield was found to be related to the deformation instability leading to kinking of lamellae oriented initially along the loading direction. Kinking was clearly shown by SAXS and microscopic observation of microtomed and etched samples. No cooperativity of kinking was observed because the lamellae are arranged in small spherulites and not parallel in stacks. The stress-strain curves were fitted with model curves assuming crystal plasticity and network elasticity in the amorphous component. The effective density of the molecular network within the amorphous phase depended on the molecular weight of UHMWPE.

Tensile Strength Statistics and Fracture Mechanism of Ultrahigh Molecular Weight Polyethylene Fibers: On the Weibull Distribution

Drawing and Ultimate Tensile Properties of Modified Polyamide 6 Fibers

Statistical Dynamic Tensile Strength of Uhmwpe-Fibers

Study on Structures and Properties of Ultra-Hot Drawing UHMWPE Fibers Fabricated Via Dry Spinning Method

Study of the Mechanical Properties of Ultra-High Molecular Weight Polyethylene Fiber Rope

Enhancing Gel Spinning of Ultra-High Molecular Weight Polyethylene: Insights into Rheology and Microstructure

Tensile Behaviour and Strength Distribution of Polyvinyl-Alcohol Fibre at High Strain Rates

Preparation of High-Modulus Poly(ethylene Terephthalate) Fibers by Vibrating Hot Drawing

Fracture failure analysis of plastic fiber based on thermodynamic strength theory and experiment

Orientation evaluation of ultra‐high molecular weight polyethylene fibers: previous studies and an improved method

Yarn on yarn abrasion failure mechanism of ultrahigh molecular weight polyethylene fiber

Morphology and Plastic Yielding of Ultrahigh Molecular Weight Polyethylene

Extended Chain Crystals of Ultra High Molecular Weight Polyethylene Fiber Prepared by Melt Spinning

The effect of shrinkage on the structure and properties of ultra‐high molecular weight polyethylene fibers with different concentration

A constitutive model of the compressive mechanical properties of ultra high molecular weight polyethylene (UHMWPE) at different temperatures and different strain rates

Temperature and Strain Rate Related Deformation Behavior of UHMWPE Fiber-Reinforced Composites

Experimental evaluation and modified Weibull characterization of the tensile behavior of tri-component elastic-conductive composite yarn

Tensile strength of polyester fiber estimated by molecular-chain extension prior to structure formation

Optimization of hot drawing process of ultra‐high molecular weight polyethylene monofilament prepared by melt spinning

Statistical Analysis on High Strain Rate Tensile Strength of T700 Carbon Fiber

The influence of formation temperatures on the crystal structure and mechanical properties of ultrahigh-molecular-weight polyethylene/high-density polyethylene-blend fibers prepared by melt spinning