Abstract:When designing buildings and structures for operation in seismically hazardous areas, constructions of increased bearing capacity are traditionally used. At present, in Ukraine and abroad, “active seismic protection systems” have been used, which reduce seismic loads on constructions. Most of the systems belong to the means of kinematic vibration isolation. Protection against vibration seismic loading is provided by devices located between the construction (building) and the supporting construction. Vibration isolators of various designs, dampers, dynamic dampers, etc. are used as such devices. As vibration isolators, constructions using elastomeric materials, mainly rubber, are most widely used. The use of elastomeric blocks in the systems of vibration and seismic protection of buildings and structures is characterized by high vertical rigidity, low shear rigidity, high energy dissipation, they have high reliability and the absence of sudden failure. Despite significant advances in the design of elastomeric parts, the simplicity of shapes and extensive experience in their application, constructions with desired physical and mechanical characteristics have not yet been created. In this regard, fairly simple and accurate calculation methods that can be used at the design stage are of great importance. The calculation of thin-layer rubber-metal vibration isolators under static compression is considered. The calculation was performed using the Ritz method for an axisymmetric problem with the assumption that axial displacements do not depend on the radius of an individual element, but are only a function of the axial coordinate. Experimental verification of the results obtained was carried out using rubber-metal vibration isolators with a diameter of 200 mm and a rubber layer height of 5 mm, 10 mm and 20 mm, which were stacked with a rubber mass of 100 mm thick. Comparison of the calculated and experimental data shows that up to the value of the element radius to height ratio equal to ten, the stiffness values practically coincide. For thinner elements, the introduction of an appropriate coefficient is required. Keywords: rubber-metal vibration isolator, thin-layer element, physically nonlinear medium, compressibility, elastic potential.

Experimental Parametric Study and Phenomenological Modeling of a Deformable Rolling Seismic Isolator

Experiment on Active Vibration Isolation of a Conical Shell Isolator

Phenomenological modeling of fiber‐reinforced elastomeric isolators at multiple lateral deformation levels

Evaluation and Performance Testing of Eccentric Rolling Isolation System

Does seismic isolation reduce the seismic vulnerability and the variability of the inelastic seismic response? Large-scale experimental investigation

Non‐linear time history analyses of a rigid block isolated with unbonded fiber‐reinforced elastomeric isolators (UFREIs): A comparison between 3D finite element and phenomenological models

Effect of uncertainty on dynamic damping and stiffness of spherical hollow rubber isolators based on harmonic experiment

Experimental study of variable-frequency rocking bearings for near-fault seismic isolation

Static and dynamic experimental validations of a frictional isolator with improved internal lateral impact behavior

Static and Dynamic Stability of Elastomeric Bearings for Seismic Protection of Structures

Experiments on Active Precision Isolation with A Smart Conical Adapter

Response and Performance of A Nonlinear Vibration Isolator with High-Static-Low-Dynamic-Stiffness under Shock Excitations

Substantiation of parameters and experimental studies of vibration isolators of high load capacity

Shaking table test of a novel Three-dimensional seismic isolation system with inclined rubber bearings

Dynamic Calibration of the Transverse Elastic Modulus of Shredded Rubber for Use in Seismic Isolation

The nonlinear dynamic behavior of a Rubber-Layer Roller Bearing (RLRB) for vibration isolation

Frictional Heating in Double Curved Surface Sliders and Its Effects on the Hysteretic Behavior: An Experimental Study

Large-scale experimental investigation of a low-cost PVC ‘sand-wich’ (PVC-s) seismic isolation for developing countries

Investigation of seismic fragility curves of unbonded FREIs: Adaptive characteristics and modeling sensitivity

Seismic performance improvement of a three-dimensional isolated spherical reticulated shell structure using pseudo-negative-stiffness magnetorheological dampers

Theory ed experimentation on passive control of adjacent structures