Abstract:The diamond-like carbon films (DLC) coated on medical titanium alloy suffer from the problem of insufficient coatings adhesion due to thermal expansion mismatch, different wetting properties at the film/substrate interface. In order to enhance DLC coatings adhesion, the titanium alloy substrate surface was pretreated by laser texturing and carburizing with different texture densities and different laser carburizing powers. The adhesion and tribological properties of the laser textured (LTC), laser carburized (LCC), and hybrid laser textured and carburized (LTCC) DLC coatings were evaluated by scratch test, indentation test and wear test, compared with the only polished DLC coatings (PC). The results showed that the bonding strength of LTC, LCC and LTCC samples was about 1.52, 1.62 and 2.14 times higher than that of PC samples, and the best tribological properties were obtained for LTCC samples. Meanwhile, the density of micro-dimples and the power of laser carburizing significantly affect the adhesion and tribological properties. Among the dent densities studied, textured samples with a density of 30 % showed the lowest mean friction coefficient and wear rate. The critical force of the carburized DLC coatings was first rising and then falling as the laser carburizing power increased, and the bond strength of the film base reached the maximum at a carburizing power of 10 W. The texturing treatment results in an improvement of the specific surface area of the substrate and the laser carburizing treatment results in an increase of the coating nucleation density and decrease of coatings graphitization degree, both improving the coatings adhesion and triboligical behavior.

Experimental Study of Diamond-like Carbon Film on Aermet100 Steel and First-Principles Calculation of Interfacial Adhesion

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Diamond-Like Carbon Thin Films Deposited On Ti6al4v Alloy Surface By Plasma Gun At Atmospheric Pressure

Excellent Adhered Thick Diamond-Like Carbon Coatings by Optimizing Hetero-Interfaces with Sequential Highly Energetic Cr and C Ion Treatment

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Diamond-like Carbon Film Synthesized by Ion Beam Assisted Deposition and Its Tribological Properties

Improved Interfacial Adhesion Between TiAlN/DLC Multi-Layered Coatings by Controlling the Morphology Via Bias

Magnetron Sputtering Preparation of Diamond-Like Carbon Film Adhesion Characteristics Research

On the growth of functionally graded self-lubricating layer during a plasma-assisted thermochemical treatment of M50NiL steel

Structural Characters and Tribological Properties of Diamondlike Carbon Films

Diamond-Like Carbon Coatings on Plasma Nitrided M2 Steel: effect of deposition parameters on adhesion properties

Study on the substrate surface micro-texturing/carburizing regulating the film-substrate adhesion and wear behavior of DLC coatings

Microstructure, wear and corrosion behavior of nano-CeO2 doped diamond-like carbon (DLC) composite films

Ion Beam Assisted Deposition of Diamond-Like Carbon Onto Steel Materials: Preparation and Advantages

Studies of Diamond-Like Carbon Films Prepared by Ion Beam-Assisted Deposition

Graphitic Encapsulation and Electronic Shielding of Metal Nanoparticles to Achieve Metal-Carbon Interfacial Superlubricity.

On the adhesion of diamond‐like carbon coatings deposited by low‐pressure plasma on 316L stainless steel

Electrodeposition, microstructure, friction and electrochemical behavior of diamond-like carbon (DLC) films with Ni/Cu interlayer

Preparation, Characterization and Tribological Properties of Diamond-Like Carbon Film on AZ31 Magnesium Alloy

Research Progress of Metal Doped Diamond-like Carbon Films

Thermal Stability of Metal-Doped Diamond-Like Carbon Fabricated by Dual Plasma Deposition