Effects of Solidification Cooling Rates on Microstructures and Physical Properties of Fe-6.5%Si Alloys
Gaoyuan Ouyang,Chad R. Macziewski,Brandt Jensen,Tao Ma,Renu Choudhary,Kevin Dennis,Lin Zhou,Durga Paudyal,Iver Anderson,Matthew J. Kramer,Jun Cui
DOI: https://doi.org/10.1016/j.actamat.2020.116575
IF: 9.4
2021-02-01
Acta Materialia
Abstract:<p>Compared to the widely used Fe-3.2wt%Si steel, Fe-6.5wt%Si has superior electric and magnetic properties, including higher electrical resistivity, lower iron loss, higher permeability, and near zero magnetostriction. However, Fe-6.5wt%Si sheet is difficult to produce using traditional manufacturing processes as the high silicon content favors the formation of ordered phases that embrittle the material. Fortunately, these ordered phases can be suppressed if the alloy is cooled fast enough from a high temperature kinetically trapping the disordered solid solution or amorphous state. Planar flow casting is known for its rapid solidification rate. In order to consider it as a viable method to manufacture ductile Fe-6.5wt%Si sheets, the effect of cooling rate on physical properties of Fe-6.5wt%Si alloy are systematically investigated. In this work, various cooling rates are achieved by changing melt-spin wheel speeds, which significantly affect the solidification temperature profile and have profound effects on ordering, microstructures, textures, hardness, and magnetic properties. High cooling rates result in refined grains, reduced ordering, enhanced <100> out of the plane texture, decreased hardness, and increased coercivity. This study shows a critical cooling rate at ∼1.7 × 10<sup>5</sup> K/s, corresponding to a tangential wheel speed of 5-7 m/s, below which the hardness significantly increases in agreement with the sudden increase of the ordered phases that causes the material embrittlement.</p>
materials science, multidisciplinary,metallurgy & metallurgical engineering