Abstract:The gas-solid vertical single helical ribbon agitated reactor is widely used in the polypropylene industry. The gas flow and mass transfer determine the heat transfer capacity and product quality. In this work, the pressure drop was measured below and above minimum fluidization velocity (umf). Then, the axial and radial dispersion coefficients (DL and DR) were estimated below umf by measuring the step residence time distribution and the stationary radial tracer profiles, respectively. Pressure analysis show the agitation significantly reduces the bed pressure drop, changing the fixed bed below umf and bubbling bed above umf to an agitated bed with a periodic voidage. The DL was proportional to the gas velocity, with little influences of the stirring speed. The radial tracer profiles show the bed is divided by the inner diameter of the helical ribbon into the peripheral ascending region and the central descending region, without gas exchange between them. Furthermore. the tracer profiles in the descending region are classified into two types. For type I, the DR, calculated by the plug flow model with radial dispersion, is proportional to the gas velocity, with little effects of stirring speed. Type II shows uniform profiles due to the deflection of the gas flow toward the low pressure area at the inner diameter of helical ribbon. The causes of the two types are explained by the relative size of particle circulation and gas flux. These two flow regimes are quantitatively clarified with an empirical correlation of Re and Fr as flow regime transition boundary, namely dispersed plug flow and perfect mixing flow. With lower Re and higher Fr, it changes from dispersed plug flow to perfect mixing flow.

Enhancement of devolatilization performance in a rotating packed bed with different packing structures

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Research and development of advanced structured packing in a rotating packed bed

Mass transfer modeling for viscous fluids in a disk-distributor rotating packed bed

Modelling investigation on the effect of single-blade pitched paddles in an EVA copolymerization autoclave reactor

Liquid dispersion behaviors in a rotating packed bed with different packing arrangements: A comparison study

Effect of Fiber Packing Density on Performance and Mass Transfer of Hollow Fiber Membrane Contactor

Effect of coating based on various hollow fiber packings on distillation of IPA/water system

3D CFD simulation of the liquid flow in a rotating packed bed with structured wire mesh packing

Physicochemical Characteristics of Hollow Fiber Structured Packings in Isopropanol/Water Distillation

Preparation and characteristics of a novel packing material for VOC gas-phase fluidized-bed bioreactor

Preparation and Characterization of a Novel Packing Material for the Gas-Phase Fluidized-Bed Bioreactor

Liquid-solid mass transfer in a rotating packed bed reactor with structured foam packing

The Application of High Gravity Rotating Packed Bed in Polymer Devolatilization

Effect of packing density of hollow fiber contactors on shell-side mass transfer in distillation

Novel Packed Bed Reactor Designed for Prileschajew Epoxidation of Fatty Acid Methyl Ester: Intensification of Mass/heat Transfer

Performance of Rotating Packed Beds in Increasing Dissolved Oxygen in Water

Computational fluid dynamic simulation of fluid flow in a rotating packed bed

Novel Wire Mesh Packing with Controllable Cross-Sectional Area in a Rotating Packed Bed: Mass Transfer Studies

Direct-Contact Condensation of Hydrocarbon Mixtures in A Structured Packing Bed

Dynamic modeling of the absorption of acetic acid in rotating packed bed