Abstract:The gas-solid vertical single helical ribbon agitated reactor is widely used in the polypropylene industry. The gas flow and mass transfer determine the heat transfer capacity and product quality. In this work, the pressure drop was measured below and above minimum fluidization velocity (umf). Then, the axial and radial dispersion coefficients (DL and DR) were estimated below umf by measuring the step residence time distribution and the stationary radial tracer profiles, respectively. Pressure analysis show the agitation significantly reduces the bed pressure drop, changing the fixed bed below umf and bubbling bed above umf to an agitated bed with a periodic voidage. The DL was proportional to the gas velocity, with little influences of the stirring speed. The radial tracer profiles show the bed is divided by the inner diameter of the helical ribbon into the peripheral ascending region and the central descending region, without gas exchange between them. Furthermore. the tracer profiles in the descending region are classified into two types. For type I, the DR, calculated by the plug flow model with radial dispersion, is proportional to the gas velocity, with little effects of stirring speed. Type II shows uniform profiles due to the deflection of the gas flow toward the low pressure area at the inner diameter of helical ribbon. The causes of the two types are explained by the relative size of particle circulation and gas flux. These two flow regimes are quantitatively clarified with an empirical correlation of Re and Fr as flow regime transition boundary, namely dispersed plug flow and perfect mixing flow. With lower Re and higher Fr, it changes from dispersed plug flow to perfect mixing flow.

Modelling investigation on the effect of single-blade pitched paddles in an EVA copolymerization autoclave reactor

Integration of CFD and Polymerization for an Industrial Scale Cis-Polybutadiene Reactor

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Modeling of Molecular Weight and Copolymer Composition Distributions for Ethylene‐propylene Solution Copolymerization

Controlling Law of Flow and Mixing Behavior in an Autoclave for the Production of Low-Density Polyethylene

Computational Fluid Dynamics Simulations and Experimental Validation of Macromixing and Flow Characteristics in Low-Density Polyethylene Autoclave Reactors

Numerical Analysis of Industrial Styrene Polymerization in Nonideal Tower Reactors

Film Flow on Rotating Wheel in a Horizontal Twin-Shaft Reactor for Polymer Devolatilization

Film Formation in a Horizontal Twin-Shaft Rotating Disk Reactor for Polymer Devolatilization

Thermal stability analysis of ethylene polymerization fluidized bed reactors under condensed mode operation through a TPM-PBM integrated model

Simulation of Biomass Pyrolysis in a Rotary Drum by Coupling CFD-DEM with a One-Dimensional Thermally Thick Model

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Hydrodynamic Instability Analysis of the Axial Flow Pump in an Ethylene Polymerization Loop Reactor

Numerical Investigation of Hydrodynamics and Heat Transfer for Bingham-pseudoplastic Fluids in an Industrial Coiled Stirred Tank

Hydrodynamics and Film Formation Characteristics in a Horizontal Self‐cleaning Twin‐shaft Kneader for Polymer Devolatilization

Research on Sludge Drying Characteristics in a Double-Axis Paddle Dryer by Coupling Markov Chain and Penetration Theory

Operational Optimization of Polymerization Reactors with Computational Fluid Dynamics and Embedded Molecular Weight Distribution Using the Iterative Surrogate Model Method

Multiscale Modeling of Mixing Behavior in A 3d Atom Transfer Radical Copolymerization Stirred-Tank Reactor

Simulation of Multi-Phase Flow in Autoclaves Using a Coupled CFD-DPM Approach

Model-Based design of a novel process applicable to solution and slurry polymerization with phase change

Optimization of Autoclave Reactors to Improve Bearing Life Using the Taguchi Method and the Response Surface Methodology