Abstract:The current study numerically investigates the flow instability under several part-load conditions in a centrifugal pump with a straight inlet pipe to explore the underlying relationship between a positive slope phenomenon and internal flow using a partially averaged Navier–Stokes model. The model was validated by comparing the hydraulic performance and averaged flow in the impeller between the numerical results and experimental data of a tested pump. The internal flows in pumps have been intensively investigated based on Batchelor vortex family, Rayleigh–Taylor criterion, entropy generation rate, and energy equation to analyze the flow instability from different aspects. The simulation results using partially averaged Navier–Stokes model are acceptable due to the good agreement with the experimental data for the tested pump. No matter the geometry of the inlet pipe, the pre-swirling flows in the inlet pipe are in the convective instability region. Under the part-load condition of φ = 0.5 φbep, the axial vorticity coefficient is affected by the geometry of the inlet pipe. However, under the part-load condition with rotating stall, e.g. φ = 0.78 φbep, the flow in the inlet pipe is affected by the unstable flow in the pump impeller. For the pump with a straight inlet pipe, the vortex inside the blade-to-blade passage is in a stable state according to Rayleigh–Taylor criterion under the condition of φ = 0.5 φbep. However, the vortex in the blade-to-blade passage is in an unstable state due to centrifugal instability under those operation conditions with rotating stall cells in the impeller, and the dominant oscillations are dependent on the propagation of rotating stall cells. Finally, head loss analysis based on energy equations elucidates that turbulent kinetic energy production term is predominant in the head loss in pump impeller. The present results are helpful for better understanding of the unstable flows and positive slope phenomenon for centrifugal pumps.

Hydrodynamic Instability Analysis of the Axial Flow Pump in an Ethylene Polymerization Loop Reactor

Numerical Investigation of Hydrodynamics and Heat Transfer for Bingham-pseudoplastic Fluids in an Industrial Coiled Stirred Tank

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Stability Analysis Of Ethylene Polymerization In A Liquid-Containing Gas-Solid Fluidized Bed Reactor

Scale-up and Thermal Stability Analysis of Fluidized Bed Reactors for Ethylene Polymerization

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Film Formation in a Horizontal Twin-Shaft Rotating Disk Reactor for Polymer Devolatilization

Structure effect of industrial loop reactors on non-uniform flow characteristics

Thermal stability analysis of ethylene polymerization fluidized bed reactors under condensed mode operation through a TPM-PBM integrated model

Computational Fluid Dynamics Simulations and Experimental Validation of Macromixing and Flow Characteristics in Low-Density Polyethylene Autoclave Reactors

Modelling investigation on the effect of single-blade pitched paddles in an EVA copolymerization autoclave reactor

Stability and dynamic behaviors of gas-phase ethylene polymerization process under condensed mode operation

Hydrodynamic Instability of Semi-concentration Fiber Suspensions Between Two Rotating Coaxial Cylinders

Study on the Four-Quadrant Homologous Characteristic and Two-Phase Flow Head Degradation of a Reactor Coolant Pump

Experimental Investigation into the Effect of Fluid Viscosity on Instability of an Over-Hung Flexible Rotor Partially Filled with Fluid

Investigation on the performance of a helico-axial multiphase pump under slug flow

Instability Analysis under Part-Load Conditions in Centrifugal Pump

Instability Study Of A Pump-Turbine At No Load Opening Based On (V(2))Over Bar - F Turbulence Model

Instability Analysis for a Centrifugal Pump with Straight Inlet Pipe Using Partially Averaged Navier–Stokes Model

Instability study of a pump-turbine at no load opening based on turbulence model