Abstract:Implantable neural stimulation is becoming increasingly popular for treating neurologically impaired patients, restoring neural functions which would otherwise be lost due to diseases or injuries. The charge balance of the stimulus pulses is of paramount importance for the long-term safety of the electrode-tissue interface. This paper presents a novel neurostimulator integrated circuit in which two novel charge balancing schemes are proposed. One is based on acquiring the access resistance part ( R S ) of the inter-electrode impedance. Thanks to its adaptive anodic phase, the R S -based charge balance circuit does not require an additional discharge phase, achieving faster charge balance than most existing stimulator ICs. The other scheme is based on acquiring the double-layer capacitance part ( C DL ) of the inter-electrode impedance and the entire charge balancing process (inc. monitoring, computation and compensation) is performed in the analog domain. This is in sharp contrast to the existing electrode-impedance-aware charge balancing schemes which require ADCs and compute the net charge in the digital domain. Hence the new impedance-aware charge-balancing scheme is faster and more power friendly. The impedance-aware stimulator ASIC has been implemented using X-FAB's 180-nm CMOS process. The post-layout simulation results suggest a good charge balance is achieved as the voltage deviation from the electrode offset voltage on the electrode after the charge compensation reduces to 2.64 mV and –1.39 mV under the R S -based and C DL -based charge balancing schemes, respectively. The additional power overhead due to the proposed C DL -based charge balancer circuit is 2.46 μW at a stimulation rate of 400 Hz.

An adaptive DC-balanced and multi-mode stimulator IC with 1GΩ output impedance for compact electro-acupuncture system

A Programmable Low Power Current Source for Bioimpedance Measurement: Towards a Wearable Personalized Health Assistant.

A wirelessly powered electro-acupuncture based on adaptive pulsewidth monophase stimulation

A Multi-Parameter Bio-Electric ASIC Sensor with Integrated 2-Wire Data Transmission Protocol for Wearable Healthcare System

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

Biofeedback Neuromuscular Electrical Stimulation Front-End for Dysphagia Treatment.

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

Energy-Efficient Power Management Interface With Adaptive HV Multimode Stimulation for Power-Sensor Integrated Patch-Type Systems

Development of implantable stimulating system used for electroacupuncture

An electrode-impedance-aware neurostimulator IC that achieves low-power consumption and fast charge balance

Charge-Mode Neural Stimulator With a Capacitor-Reuse Residual Charge Detector and Active Charge Balancing for Epileptic Seizure Suppression

A High-Voltage-Compliant 86% Peak Efficiency Current-Mode Stimulator with Dynamic Voltage Supply for Implantable Medical Devices

A Low-Power Stable Wideband Current Source for Acupuncture Point Skin Impedance Measurements

A 0.6V 3.8μw ECG/bio-impedance Monitoring IC for Disposable Health Patch in 40nm CMOS

A High-Voltage, Energy-Efficient, 4-Electrode Output Stage for Implantable Neural Stimulator

A 15.7-V-Compliant 86% Peak Efficiency Current-Mode Stimulator With Dynamic Voltage Supply for Implantable Medical Devices

A low-power, 16-channel implantable neurostimulator

A 36μw Reconfigurable Analog Front-End IC for Multimodal Vital Signs Monitoring

Design Of A Compact Wireless Multi-Channel High Area-Efficient Stimulator With Arbitrary Channel Configuration

A 3-mV Precision Dual-Mode-Controlled Fast Charge Balancing for Implantable Biphasic Neural Stimulators

A Charge Balanced Neural Stimulator Silicon Chip for Human-Machine Interface