Abstract:This paper presents a low power reconfigurable IC for wearable health devices that perform bio-impedance (BioZ) spectroscopy, respiration, and ECG signals measurement. The IC consists of a broadband excitation current source (I-DAC) and a power efficient readout circuit (RO). Both are highly scalable to mitigate the tradeoff among noise, dynamic range, speed, power, and safe current limits. On circuit level, the I-DAC supports two broadband excitation modes based on maximum length sequence (MLS), a flexible selection of frequency points, bandwidth, and current magnitude. The RO employs a low noise instrumentation amplifier and a reconfigurable 8-to-12 bit ADC for flexible sensitivity, dynamic range and speed with an automatic scaling of the power consumption. On system level, calibration of the entire circuit chain, oversampling and MLS averaging further improve the bandwidth, accuracy and sensitivity of BioZ spectroscopy beyond the intrinsic circuit performance. As a result, the BioZ sensor IC achieves 2 $\text{m}\Omega $ sensitivity within 3.3 $\text{m}\Omega $ – $100~\Omega $ range and $0.6~\Omega $ sensitivity within $3.3~\Omega $ –100 $\text{k}\Omega $ range. The BioZ spectroscopy spans up to 125 kHz while consuming $155~\mu \text{W}$ . Furthermore, this IC can measure respiration and ECG simultaneously at a lower sampling rate of 20 kS/s while consuming $31~\mu \text{W}$ . Compared to prior art, to the best of our knowledge, this IC is the only work that can measure BioZ and ECG simultaneously with a single readout channel while consuming the lowest power and offering the highest flexibility in performance, application range, and power consumption.

A 36μw Reconfigurable Analog Front-End IC for Multimodal Vital Signs Monitoring

A 36 Μw 1.1 Mm 2 Reconfigurable Analog Front-End for Cardiovascular and Respiratory Signals Recording

A receiver analog front-end for body sensor network

A Multi-Parameter Bio-Electric ASIC Sensor with Integrated 2-Wire Data Transmission Protocol for Wearable Healthcare System

A 1.0 V 78 μw Reconfigurable ASIC Embedded in an Intelligent Electrode for Continuous Remote ECG Applications

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

A low-offset analogue front-end IC for multi-channel physiological signal acquisition

A 1.7μW/Channel Time-Division-Multiplexing Analog Front-End for Bio-Potential Recording

A 0.6V 3.8μw ECG/bio-impedance Monitoring IC for Disposable Health Patch in 40nm CMOS

A 20 Μw Dual-Channel Analog Front-End in 65nm CMOS for Portable ECG Monitoring System

An Energy-Efficient and Reconfigurable Sensor IC for Bio-Impedance Spectroscopy and ECG Recording

Design of an Analog Front-End for Ambulatory Biopotential Measurement Systems

A 4-Μw Analog Front End Achieving 2.4 NEF for Long-Term ECG Monitoring

A Low Power Low Noise Analog Front End for Portable Healthcare System

A low power analog front-end for portable biopotential acquisition systems

An Integrated Analog Front-End System on Flexible Substrate for the Acquisition of Bio-Potential Signals

A 15.5b-ENOB 335mVpp-Linear-Input-Range 4.7GΩ-Input-Impedance Direct-ADC Based Analog Front-End

A 0.8 V, 14.76 nVrms, Multiplexer-Based AFE for Wearable Devices Using 45 nm CMOS Techniques

A 15-Channel Digital Active Electrode System for Multi-Parameter Biopotential Measurement

An AFE for Catheter-Based IEGM Sensing with Inverter-based SAR ADC