Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

A Systematic Investigation of PbSe Thermoelectric Material

Study of the Thermoelectric Properties of Lead Selenide Doped with Boron, Gallium, Indium, or Thallium.

Modulating the Valence of Ga and the Deep Level Impurity for High Thermoelectric Performance of N-Type Pb0.98Ga0.02Te1-xSex Compounds

Electronic Structures and Thermoelectric Properties of (ag, Te), (sn, Te) and (sb, Te) Dually Doped PbSe on Cationic and Anionic Sites

Boosting the Thermoelectric Performance of PbSe from the Band Convergence Driven By Spin‐Orbit Coupling

Optimizing the thermoelectric performance of n-type PbSe through dynamic doping driven by entropy engineering

Enhancement of thermoelectric performance of Cu 1.98 Se by Pb doping

Enhanced Thermoelectric Performance of PbSe Co-Doped with Ag and Sb

Preparation of Heavily Doped P-Type PbSe with High Thermoelectric Performance by the NaCl Salt-Assisted Approach

Enhancing Thermoelectric Performance of p-Type PbSe through Suppressing Electronic Thermal Transports

High Thermoelectric Properties for Sn-doped AgSbSe 2

High Thermoelectric Performance of Ge1−xPbxSe0.5Te0.5 Due to (pb, Se) Co-Doping

Enhanced Thermoelectric Performance of P-Type SnSe Doped with Zn

Ag, Pb co-doped SnSe high performance thermoelectric materials

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Enhancement of low-temperature thermoelectric performance via Pb doping in Cu3SbSe4

Enhanced Average Power Factor and ZT Value in PbSe Thermoelectric Material with Dual Interstitial Doping

Strategies for boosting thermoelectric performance of PbSe: A review

Synthesis and Thermoelectric Properties of Ag-Doped Snse

High‐Performance GeSe‐Based Thermoelectrics via Cu‐Doping

Thermoelectric Properties of Mg doped Mercury Selenide HgSe