Abstract:This article shows that Sn can effectively fill intrinsic Pb vacancies in PbSe, significantly enhancing the mobility of the material. The dynamic doping of Cu effectively improves the electrical transport properties over a wide temperature range, and also valid to suppress the lattice thermal conductivity. The resulting PbSn0.004Se+3‰Cu obtained a maximum ZT of ≈1.7 at 800 K. Ideal thermoelectrics shall possess a high average ZT, which relies on high carrier mobility and appropriate carrier density at operating temperature. However, conventional doping usually results in a temperature‐independent carrier concentration, making performance optimization over a wide temperature range be challenging. This work demonstrates the combination of lattice plainification and dynamic doping strategies is an effective route to boost the average ZT of N‐type PbSe. Because Sn and Pb have similar ionic radii and electronegativity, this allows Sn to fill the intrinsic Pb vacancies and effectively improves the carrier mobility of PbSe to 1300 cm2 V−1 s−1. Furthermore, a trace amount of Cu is introduced into the Sn‐filled PbSe to optimize the carrier concentration. The extra Cu is situated in the interstitial sides of the lattice, which undergoes a dissolution‐precipitation process with temperature, leading to a strongly temperature‐dependent carrier density in the material. This dynamic doping effectively improves the electrical transport properties and is also valid to suppress the lattice thermal conductivity. Ultimately, the resulting PbSn0.004Se+3‰Cu obtains a maximum ZT of ≈1.7 at 800 K and an average ZT of ≈1.0, with a 7.7% power generation efficiency in a single‐arm device, showing significant potential for commercial application.

Enhanced Thermoelectric Performance of P-Type SnSe Doped with Zn

High Thermoelectric Performance of Co-Doped P-Type Polycrystalline SnSe Via Optimizing Electrical Transport Properties

Enhanced Thermoelectric Performance in N-Type Polycrystalline SnSe by PbBr2 Doping

Studies on thermoelectric figure of merit of Na-doped p-type polycrystalline SnSe

Realizing High Thermoelectric Performance in Slightly Na-doped SnSe Polycrystals

High Thermoelectric Performance in P‐type Polycrystalline Cd‐doped SnSe Achieved by a Combination of Cation Vacancies and Localized Lattice Engineering

Enhanced Thermoelectric Performance in SnSe Based Composites with PbTe Nanoinclusions

High Thermoelectric Properties for Sn-doped AgSbSe 2

Re‐Doped p‐Type Thermoelectric SnSe Polycrystals with Enhanced Power Factor and High ZT > 2

Enhanced thermoelectric performance of n-type polycrystalline SnSe via NdCl3 doping

Raising thermoelectric performance of n-type SnSe: Via Br doping and Pb alloying

Excellent thermoelectricity performance of p-type SnSe along b axis

Robustly Boosting Thermoelectric Performance of N‐Type PbSe via Lattice Plainification and Dynamic Doping

Ultrahigh Average ZT Realized in P-Type SnSe Crystalline Thermoelectrics Through Producing Extrinsic Vacancies.

Study on the Thermoelectric Properties of n-Type Polycrystalline SnSe by CeCl 3 Doping

Realizing High Thermoelectric Performance in p-Type SnSe Crystals via Convergence of Multiple Electronic Valence Bands

Broad temperature plateau for high ZTs in heavily doped p-type SnSe single crystals

Study on the Thermoelectric Properties of N-Type Polycrystalline SnSe by CeCl3 Doping

Realizing High Thermoelectric Performance in P-Type SnSe Through Crystal Structure Modification

Enhanced thermoelectric performance of AgCuTe-doped polycrystalline SnSe by lattice plainification

High thermoelectric properties in polycrystalline SnSe materials realized by rare earth halide Co-doping