Accurate determination of thermoelectric figure of merit using ac Harman method with a four-probe configuration

Kenjiro Okawa,Yasutaka. Amagai,Norihiko Sakamoto,Nobu-Hisa Kaneko
DOI: https://doi.org/10.1016/j.measurement.2024.114626
2024-04-02
Abstract:The ac Harman method has been used for the direct estimation of dimensionless thermoelectric figure of merit (zT) through ac/dc resistance measurements. However, accurate zT estimation with a four-probe configuration is difficult owing to the occurrence of a thermal phase-delay in the heat flow with a low frequency current. This study reports an exact solution for zT estimation by solving the heat conduction equation. The analysis can explain the reverse heat flow, which is the main source of the error in the four-probe configuration, and the experimentally obtained behavior of the frequency dependence of zT of (Bi,Sb)$_2$Te$_3$. Approximately 20 % of the error is caused by a thermal phase-delay, unless an appropriate current frequency and voltage-terminal position are chosen. Thus, an accurate zT evaluation using a four-probe configuration at any voltage terminal position is achieved. These findings can lead to interesting thermoelectric metrology and could serve as a powerful tool to search for promising thermoelectric materials.
Materials Science,Applied Physics
What problem does this paper attempt to address?
The problem this paper attempts to address is: how to accurately measure the dimensionless thermoelectric figure of merit (zT) of thermoelectric materials using the ac Harman method in a four-probe configuration. Specifically, the paper addresses the following issues: 1. **Thermal phase delay issue**: At low-frequency currents, thermal phase delay occurs in the four-probe configuration, leading to measurement errors. This delay is caused by the phase mismatch between the thermal wave and the sample's thermal response. 2. **Sources of measurement error**: The paper analyzes the main sources of error in measuring zT in the four-probe configuration, including thermal phase delay, Joule effect, and thermal conduction and convective heat loss in the wires. 3. **Accurate solution**: The paper proposes an accurate solution by solving the heat conduction equation to explain the reverse heat flow phenomenon and verifies the consistency between experimental results and theoretical predictions. 4. **Optimizing measurement conditions**: The paper discusses how to choose the appropriate current frequency and voltage terminal positions to reduce measurement errors and achieve accurate zT evaluation. Through these studies, the paper provides new tools and methods for the precise measurement of thermoelectric performance, aiding in the discovery and development of high-performance thermoelectric materials.