Abstract:This paper presents a setup for measuring the Seebeck coefficient and the electrical resistivity of bulk thermoelectric materials. The sample holder was designed to have a compact structure and can be directly mounted in a standard cryostat system for temperature-dependent measurements. For the Seebeck coefficient measurement, a thin bar-shaped sample is mounted bridging two copper bases; and two ceramic heaters are used to generate a temperature gradient along the sample. Two type T thermocouples are used to determine both temperature and voltage differences between two widely separated points on the sample. The thermocouple junction is flattened into a disk and pressed onto the sample surface by using a spring load. The flexible fixation method we adopted not only simplifies the sample mounting process but also prevents thermal contact deterioration due to the mismatch of thermal expansion coefficients between the sample and other parts. With certain modifications, the sample holder can also be used for four-probe electrical resistivity measurements. High temperature measurements are essential for thermoelectric power generation. The experimental system we developed is capable of measuring the Seebeck coefficient and the electrical resistivity of bulk thermoelectric materials in a wide temperature range from 80 to 500 K, which can be further extended to even higher temperatures. Measurements on two standard materials, constantan and nickel, confirmed the accuracy and the reliability of the system.

Ac heating-dc detecting method for Seebeck coefficient measurement of the thermoelectric micro/nano devices

A Self-Heating 2ω Method for Seebeck Coefficient Measurement of Thermoelectric Materials.

Novel Ac Heating–dc Detection Method for Active Thermoelectric Scanning Thermal Microscopy

Simultaneous thermal conductivity and specific heat measurements of thin samples by transient Joule self-heating

A Setup for Measuring the Seebeck Coefficient and the Electrical Resistivity of Bulk Thermoelectric Materials

A METHOD FOR THERMOELECTRIC MEASUREMENTS ON MESOSCOPIC SAMPLES

Direct Mapping of Local Seebeck Coefficient in 2D Material Nanostructures via Scanning Thermal Gate Microscopy

Measurement and Analysis for Performance of Micro-thermoelectric Generator

Precise measurement of absolute Seebeck coefficient from Thomson effect using ac-dc technique

Data Fitting and Analysis of Performance for Micro-thermoelectric Generator

Three-wire Method to Characterize the Thermoelectric Properties of One-Dimensional Materials

A New Laser-Combined H-Type Device Method for Comprehensive Thermoelectrical Properties Characterization of Two-Dimensional Materials

Spin Seebeck devices using local on-chip heating

Apparatus for the room temperature measurement of low field Nernst and magneto-Seebeck coefficients

Method and system for measuring quasi one-dimensional nano-material Seebeck coefficient

Direct observation of hot-electron-enhanced thermoelectric effects in silicon nanodevices

An in-situ thermoelectric measurement apparatus inside a thermal-evaporator

Toward thermoelectric characterization of (nano)materials by in situ transmission electron microscopy

High-throughput imaging measurements of thermoelectric figure of merit

Reliable Measurements of the Seebeck Coefficient on A Commercial System